Electronics Forum | Thu Mar 28 15:18:21 EDT 2024 | tey422
From the error message, might have to do with the "Z"-axis. You didn't mention you redo the calibration or not, then you should run that too. My guess would be "Z reading maybe slightly off". BTW, last time I work with those Mydata machine were bac
Electronics Forum | Tue Jan 11 16:36:52 EST 2005 | OverTheHill
Update: I replaced the Z sensors in the tool head and the Z sensor cable. Fingers crossed........ I'll keep you all posted. P.S. "Have Fun"? I'm at work, thus not having fun!!!!!
Electronics Forum | Fri Oct 12 11:16:46 EDT 2018 | tech1
Sounds like one of the Z stops is not functioning or needs to be adjusted.
Electronics Forum | Wed Oct 24 07:33:44 EDT 2018 | tech1
when the machine initiates the last move it does is in the Z axis. If memory serves me, during the last Z move it drives down and measures the stroke, if the lower solenoid is not fully retracted the axis measures the wrong travel limits. Hopefully t
Electronics Forum | Fri Feb 21 17:12:43 EST 2020 | SMTA-Alex
Have you performed the maintenance? It might need grease, or there might be excess old grease, that's putting more friction on the Hydra Z. Check if there might be interference from the vacuum tubes or wires.
Electronics Forum | Tue Mar 03 12:36:14 EST 2020 | tomdegas
I cleaned and re-greased everything on the Hydra head and I even changed the motor and encoder and it still gives me the timeout error Z/156. Where do I look now? My machine has been down now for 3 weeks.
Electronics Forum | Tue Mar 03 13:35:29 EST 2020 | emeto
So to sum up: you have no mechanical blockage, you have new motor and encoder. That leaves only two more parts(cable and Hydra Z-Controller).
Electronics Forum | Tue Mar 03 13:40:44 EST 2020 | tomdegas
I swapped out the cable with no luck. The Hydra Z controller is the board on the right side of the Hydra head with everything plugged into it right?
Electronics Forum | Sat Apr 04 04:53:58 EDT 2020 | tima
Have you try doing initialization from service menu? Exit TPsys, type service -x and try to initialize only Hydra Z. See what error you get. Can be too much friction on the shaft. Run friction test
Electronics Forum | Tue Sep 16 09:26:26 EDT 2008 | mi
Hello, I have programmed SMT placement for Mydata My9 machines. I have ported programs between Mydata-to-Mydata machines. Also from Mydata to AOI machine for SMT inspection. Is there a way to port a placement program from Mydata to Panasonic MSH2