Electronics Forum | Thu Jul 12 07:52:08 EDT 2007 | cyber_wolf
I agree avalancher. Your description is a valid point. But, I am still under the impression that the vac level is a separate issue. His original problem was 0402's missing off the board ,and weird measurements showing up when parts get rejected. I w
Electronics Forum | Tue Oct 23 11:18:23 EDT 2018 | tech1
It is probably one of the Z lock solenoids not working properly. These are located along the Z axis and as part of the initiation of the machine, the Z measure the travel. Check the upper and lower Z locks
Electronics Forum | Tue Jul 10 16:13:52 EDT 2007 | bk
Hi folks, I've been bouncing off of MyData > technical support for some time on an issue with > a MyData machine. Seems that this My9 likes to > skip an 0402 placement at a rate of ~ > 1000/million. > > Profile: MyData > My9 Mechanical ce
Electronics Forum | Tue Nov 13 12:02:54 EST 2012 | jaimebc
I'll try swaping cards and see if the problem follows the card. So far, my guess would be the motor going bad. I did change the brushes, X wagon cables and every cable that goes to the midas unit. But that didn't fix it. The problem is that to replac
Electronics Forum | Thu Jul 31 07:28:04 EDT 2008 | leemeyer
This sounds like a Quadalign problem. Upon startup the Quadalign system checks runout of the Z-rod and tries to find the tip of the nozzle. It will keep lowering the Z-rod and looking for the tip until it hits it's limit. Check and see if the Quadali
Electronics Forum | Sat Jun 25 01:05:13 EDT 2005 | pci
check the X axis belt , guides and Z axis motor
Electronics Forum | Fri Nov 26 15:19:53 EST 2010 | mtech88
I Just got a Mydata M9 machine, It was working at the beginning. And now the Z-axis always come up a "out of limit" problem when machine is starting up. can any one help? or come in my factory to cal. the machine for us. We are in Los Angeles, CA.
Electronics Forum | Thu Mar 28 15:18:21 EDT 2024 | tey422
From the error message, might have to do with the "Z"-axis. You didn't mention you redo the calibration or not, then you should run that too. My guess would be "Z reading maybe slightly off". BTW, last time I work with those Mydata machine were bac
Electronics Forum | Tue Jan 11 16:36:52 EST 2005 | OverTheHill
Update: I replaced the Z sensors in the tool head and the Z sensor cable. Fingers crossed........ I'll keep you all posted. P.S. "Have Fun"? I'm at work, thus not having fun!!!!!
Electronics Forum | Fri Oct 12 11:16:46 EDT 2018 | tech1
Sounds like one of the Z stops is not functioning or needs to be adjusted.
