Electronics Forum | Thu Jan 13 15:08:22 EST 2022 | emeto
Hello Jeff, error is telling you exactly what it is - communication problem. CAN interface is interrupted somewhere. Motors are constantly sharing position and commands with computer over CAN interface. To get this message means somewhere this circui
Electronics Forum | Sat Jan 15 16:45:46 EST 2022 | goseese
I don't seem to be finding any loose connections. I am starting to suspect perhaps the rising table driver, BGE9010C, or the Motor it's self. I just don't know how to prove one or the other. How sensitive to pressure should the table be? While jo
Electronics Forum | Thu Dec 22 16:59:39 EST 2022 | goseese
My problem was the BGE9010C. Any time there was any pressure on the rising table the error would occur. I was not able to find a replacement BGE9010C so I opened it up and found some blown components. Replaced them and the problem was solved. I "
Electronics Forum | Sun Feb 13 01:35:55 EST 2000 | Dean
Without further information my first guess would be lack of flux to "cut through" the ENTEK layer. Question: In X-ray is the suspect ball of equal diameter when compared to adjacent balls? If no then the volume of solder is different which would po
Electronics Forum | Tue Jul 20 06:36:50 EDT 1999 | Peter Brant
| Dear all | Please help me to know what kind of tests usually done after SMT Pick & place and reflow oven. | Our appliocation is Mainly fabrication of mother boards. | Thanks | Hi, The usual method is ATE, also known as a "Bed of nails" Basicall
Electronics Forum | Wed Oct 20 07:42:24 EDT 2004 | rlackey
Hi Arman, There are a number of sites dealing with the Corona Effect all with different slants in how it applies to them (Astonomers, physicists, Radio enthusiasts, etc.), but the basic definition I remember from my physics lessons at school is as f
Electronics Forum | Thu Nov 10 23:09:45 EST 2005 | davef
Poured flooring suppliers are: * Garland Floor http://www.garlandfloor.com * Sauereisen http://www.sauereisen.com/c_prod/c_esd.htm Vinyl & rubber flooring suppliers are: * VPI http://www.vpiflooring.com/products.php?cat=2⊂=1 * 3M http://products3
Electronics Forum | Tue Mar 27 10:38:04 EDT 2007 | johansenng
Hi, sorry but i am new in this. This is a Freescale SRB ZigBee node schematic design. 1)Can anyone help me identify what is the use of the 10K ohm resistor (R115) used? Seems that there is some advantages and disadvantages of using it. The source is
Electronics Forum | Tue Nov 25 11:58:31 EST 2008 | rway
Hello all, We are using z1850/60 machines. The APC test is damaging a 1.8V device on the board. The APC stimulates -/+3Vdc in fast mode. I understand the dangers of over-voltage. But what I need to know is how the part is being damaged when the ent
Electronics Forum | Tue Aug 21 19:24:15 EDT 2012 | rway
Checksum will work if all your doing is analog/passive testing. Checksum systems do not have digital test capability. I would recommend a Teradyne z18xx system. We use 8 of them in our plant and have been for years. Used, these systems range from
