Electronics Forum | Tue Nov 01 09:36:41 EDT 2011 | emeto
THe question is - does that happen on all of your programs or just in one program? If it is just this particular board, it might be some softwaRE limit issue. If it happens on more programs it is a hardware issue and it could be one of the following:
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Fri Jul 09 23:45:22 EDT 2010 | dman97
I have a CP642 machine that always gives me a Station 17 or Station 19 nozzle error when the machine selects the 2.5mm 3.7mm or 5.0mm nozzles. It always throws an unknown nozzle station 17 error after all the heads have switched to the above mention
Electronics Forum | Thu Jul 31 14:07:44 EDT 2014 | kurtiss
I found a bad solenoid and replaced it solenoid 15 on station 11. The machine is still erroring out. I also checked the holders and sensors and they seem to be ok. This error occurs when ever the machine tries to change nozzle sizes on any holder. T
Electronics Forum | Sun Mar 21 22:03:35 EST 1999 | Nick
It looks like your holders now require some maintenance. You will need to throughly clean all the holders of all dirt debris and then relube the holder lightly with T&D or grease. You will only need to lube the shaft of the nozzle change enagager an
Electronics Forum | Fri Apr 06 02:17:15 EDT 2018 | rob
@ Sr.Tech, Most of our Chinese spares are Juki & Yamaha original & still bagged, just much cheaper. They wouldn't sell machines in China if all the spares and consumables were at European mark ups. Nozzle wise the Juki 750 & 760 copies are not 100%
Electronics Forum | Wed Mar 02 10:49:45 EST 2005 | Dave Erbst
Try checking your Z height and also make sure that they are cleaned regularly. If the Z height is off your will be pressing your nozzles into the holders thereby causing them to bind up inside the holder. Replace the springs periodically since they d
Electronics Forum | Wed Sep 02 16:47:03 EDT 2015 | curiousman
Hi all, My company recently purchased a preowned EBSO SPA 400-F, and I am trying to get it up and running. Still need to get a few other parts like a nozzle and nitrogen generator, but in the meantime I was looking to clean out the residues and oxid
Electronics Forum | Tue Mar 19 11:54:56 EDT 2024 | tommy_magyar
Hi there, I've been happy with the iiNeo and iiNeo+ from Europlacer, both have the capacity of 8*33 8mm feeders (264 slots in total). It can build boards up to 505*360 mm (our biggest PCBA, maybe it can do bigger one too). 6 and 12 monthly services
Electronics Forum | Mon Feb 05 12:57:35 EST 2007 | cyber_wolf
Take the nozzles out and let the indicator tip touch the metal face the nozzle pushes up into. This will tell you whether the variation is in the shaft or the nozzles. Also while your indicator is touching the holder, manually grab the shaft assy a