Electronics Forum | Wed Feb 01 00:10:32 EST 2006 | kent
Are you seeing this problem with the nozzles after an error stop? Well check station 15 confirm nozzle clutch origin. It will cause this problem. If you rotate a shaft (with the machine stopped) 45 degrees and start you will get return theta off and
Electronics Forum | Mon Jan 29 15:49:08 EST 2007 | rmitchell
Hi, Our Fuji CP65 nozzles are jamming in the up position. Mostly on caps and resistors, the .7mm (0402) and 1.0mm (0805) and 1.3mm (1206) sizes. They seem to be catching internally where the little peg slides down the slot. If you twist them they
Electronics Forum | Wed Jul 03 14:16:09 EDT 2013 | horchak
Hi, I had seen your post earlier but had lost my very old log on information. First I will say that BGAs should never be placed and re-flowed with a rework station unless there is absolutely no other option, so I don't understand why your assembly ho
Electronics Forum | Sun Mar 15 23:48:59 EST 1998 | Phill Hunter
| | | Has anyone had any success in repairing Fuji CP nozzles in house? Removing bent press fitted nozzle and replacing. Any input would be appreciated, please no solicitation from repair shops | | Rob, | | What model of CP? | Mr. Kooki | CP4 and 6
Electronics Forum | Mon Jul 28 18:31:43 EDT 2003 | mantis
Hi There, First has the machine in question had the camera upgraded to accomdate 0603/0402. It sounds like there is a bad pickup on this part.Are all nozzles ok is feeder indexing correctly has part pick up position(Station 1) been calibrated. Hope t
Electronics Forum | Thu Jul 07 19:39:18 EDT 2005 | darby
This is a very difficult question to answer as it will depend greatly on your component mix. I will presume that the CSM 84VZ is of the following configuration: 2 x RDC Synchro Heads. Heads 1 & 2. These are mechanically centering heads with a chucki
Electronics Forum | Tue Jul 19 18:08:28 EDT 2016 | dman97
Hello, I am having trouble getting our old CP3 to start up. When the machine starts to run, or when we try to center the nozzles, the CAM moves to 300 degrees and stops. The station 5 rotor just turns and turns with out ever centering the nozzles.
Electronics Forum | Mon Apr 16 09:01:18 EDT 2007 | Steve
The best station I've ever worked with is a focused IR station from PDR. The station that I had was called a; "Lightmaster Pro". They have a different model name now, but you can see a datasheet for it at: http://www.pdr.co.uk/Datasheets/PDRX410-IR-
Electronics Forum | Fri May 04 02:32:10 EDT 2007 | jmelson
Thanks! Well, the procedure in the book says to first calibrate the mech aligner with the beam sensor, but that exceeds the X travel. I guess you can just eyeball it off the nozzles and then use trial and error. While poking around on the machine
Electronics Forum | Thu Jan 24 10:38:37 EST 2008 | vikkaraja
Hellow there, I need some help with a very old CP machine. It worked great until this past week.All of sudden it stoped woking. It does not index the feeder during production.I checked rotary selonoids already in the CAM box for first station and noz
