Electronics Forum | Thu Jul 22 06:08:18 EDT 2004 | hitechsc
Hi julie I found that it was the sleeve on the ball bearing that was the fault we went back to the oring type problem gone.
Electronics Forum | Wed Jul 20 22:46:41 EDT 2005 | nozzles
we can supply nozzle for varies machine brand,such as fuji,sanyo and so on. welcome to inquiry that!thanks vera http://www.hkenterprise.com/szcomfaje tel:86-755-28091605 ext.805 eskimy1001@gmail.com
Electronics Forum | Tue Jul 05 09:25:25 EDT 2005 | smtuser1234
If the nozzle adapter is new then the nozzle are worn. How old are the nozzles ?
Electronics Forum | Thu Feb 25 15:05:17 EST 2010 | flipit
Multiport nozzles will work better if your pickup is not perfect. Has been a while but are the nozzles 08MPF? I used to pick 0402 chips with 08MPF nozzles. These had 5 holes and were black Delrin plastic. I looked at the 0402 using front lighting
Electronics Forum | Tue Jul 05 10:27:34 EDT 2005 | GEB
The nozzles are brand new too (got them friday). 08MPF (0.08") is their part number. I tried using the air kiss feature in the setup mode and found that it blew the nozzle off the nozzle holder, not sure if this is ment to happen in this mode, but t
Electronics Forum | Sun Jul 08 06:38:41 EDT 2007 | dilogic
We have an old GSM1 (I-block, USOS V1.4.14, two 4-spindle heads, changers between rails). When I configure machine so there are no nozzles on heads and changers are filled with required nozzles, except for one empty hole, machine won't pick up nozzle
Electronics Forum | Thu Nov 03 11:31:51 EDT 2022 | proceng1
You described cleaning the spindles and filters, but did you clean the nozzles? Perhaps you got some paste on the nozzle. Also, did you perform the vacuum and blow off testing? Make sure your solenoids are working properly. Is it all 6 heads that
Electronics Forum | Mon Jul 09 11:19:07 EDT 2007 | swag
I could be wrong but I don't believe that you can start with any empty spindles. If it picks up nozzles, you will end up with more than one empty changer hole which will not work for the vacuum that is required to remove the nozzles from the spindle
Electronics Forum | Thu Jan 03 10:32:38 EST 2013 | beej
I was wondering if any of you fine folks had a trick to changing out nozzles for a Pillerhouse Jade Handex. The tool they gave us when we purchased the machine is inadequate at best. I have tried heating the nozzle up, to no avail. Just wondering if
Electronics Forum | Thu Jan 03 14:19:33 EST 2013 | uksolder
Beej, The tool supplied works well as long as the bath is up to temp and the nozzle tip was not cross threaded when fitted. Did you apply a small amount of the anti seize paste before the nozzle tip was fitted? I have seen dry tight threads if not ap
We are a global electronics manufacturing Solutions provider ....Our company supplies new and used SMT equipment, spare parts, consumibles, ESD supplies and services to a wide range of EMS companies.
Equipment Dealer / Broker / Auctions
Parque Industrial Nogales No. 5297 Zapopan
Jalisco, Mexico
Phone: 523316044491