Electronics Forum | Mon Dec 14 17:16:15 EST 2020 | vielki
Hi Bob, Can you send me manual ? my mail master_tail@op.pl
Electronics Forum | Fri Oct 13 15:01:14 EDT 2017 | tombstonesmt
People do ask to be spoon fed on here just like any forum or facebook page. If it's common knowledge the OP gets roasted by senior members. Not offended, just surprised since it was the first time I've witnessed it here. Carry on.
Electronics Forum | Fri Aug 02 16:48:22 EDT 2019 | slthomas
Based on the lack of participation by the OP you may very well be right as far as how much time this discussion merits. For all we know he may very well have been looking for one of these:
Electronics Forum | Thu Aug 08 10:32:30 EDT 2019 | SMTA-Joe
Ok, interesting. Unfortunately I can't speak on that. We always treat these as a 2nd ops and have never had a problem. We determined it was something that could add to thermal trouble. Also, the amount of solder added during paste deposition may not
Electronics Forum | Mon Jun 28 11:21:59 EDT 2021 | cyber_wolf
Both companies are good. I had no red flag experiences with either. Tell your OP that it pays to do your due diligence on your specific product and equipment. You may have variables that differ from others.
Electronics Forum | Tue Nov 16 16:15:06 EST 2021 | kumarb
To future readers, ignore this thread. The OP should have posted that the issue was resolved on Saturday so that others do not have to waster their time in attempting to assist. Irv (factory) replied to confirm the same. You are welcome.
Electronics Forum | Thu Mar 21 15:31:16 EDT 2024 | carl_p
That's possible but the OP doesn't state that so it's a bit open as it could be something else.
Electronics Forum | Fri Aug 25 11:29:09 EDT 2006 | mika
Thanks all for Your input. The thing is that we want to avoid to go in to the pattern program and change the height in the middle of running a board. For ex. We start a product, feeders are loaded in advance in the feeder preparation area, operator
Electronics Forum | Fri May 04 19:23:28 EDT 2007 | darby
System > Machine Config > Mechanical OP > Head 3 Spec = Vision. Data In > System > Machine Config > Mechanical OP > M Centering 1 = Yes If your Centering unit is a two stage unit then also set M Centering 2 = Yes You should then be able to roughly
Electronics Forum | Fri Jun 24 22:36:17 EDT 2016 | yokywong
now days, I face a problem for JUKI electric feeder and machinery feeder. i do not know about any of electric feeder. until now, we all use machinery feeder for CF081ER 7' real holder and 15' real holder,CF03HPR ,FF12FS,FF16FS,AF24FS-OP. but this tim