Electronics Forum | Sat Nov 01 04:12:53 EDT 2008 | ashley
Hello mickd, The Fiducial Marks are normally etched along the vertical side of the PCB, therefore it will not be block by the XY table clamping rails. p.s. try to have a Shiny & Round Fiducial Mark as recommended by Fuji....so that you need not inp
Electronics Forum | Thu Oct 15 14:43:58 EDT 2009 | dilogic
I assume your global fiducials are on the panel, but outside circuit area. If you circuits are not placed exactly as in the program, globals would be located, but locals won't. At least, older UPS versions work like that. - Deni P.S. By the way, as
Electronics Forum | Thu Nov 26 06:48:39 EST 2009 | pavel_murtishev
Gentlemen, Could you please give me a link to manufacturers of standalone traceability systems for electronic industry? I do not want to have a system integrated into a placement machine or a screen printer. It would be great if a system was able to
Electronics Forum | Mon Apr 09 06:39:50 EDT 2012 | eniac
Last 4 years I work with printer by SJ Inno Tech, model HH-520. This model have all what you want - fully automatic alignment, 2D inspection, many different pins for PCB fixing - and no any problems during this 4 years. P.S. Sorry for my English, I'
Electronics Forum | Tue Feb 05 19:00:18 EST 2013 | marcelorotofrance
I found problem, it was a faulty connector on the align processor card. So, Mr. Bobpan, I thank you very much for your invaluable guidance. P.S. My employer has been very clever and have purchased a 18 years old/ 25000 run hours/ third-hand equipmen
Electronics Forum | Thu May 10 05:46:29 EDT 2018 | ringelgr
Hi We are using a Sony SI-F209,yesterday we encounter strange error. The machine fails to start any servo motors and we get the message shown at the attachment. Hope someone can figure it out cause we're really stuck right now. We spoke with the com
Electronics Forum | Tue Jul 10 08:45:12 EDT 2001 | stefwitt
There are several low cost vision systems ( under $ 5,000) on the market: http://www.dvtsensors.com" ,Keyence, Texas Instruments, Imagenation. If they can capture the image in one shot ( comparing with one good board ) depends on the camera resolutio
Electronics Forum | Sat Dec 11 11:01:11 EST 1999 | Mark W.
In answer to your question no. Fiducials should always be as far apart from each other in both directions (X,Y) as possible. This will allow ANY placement machine to calculate the EXACT location and rotation of the PCB, and therefore correct the moun
Electronics Forum | Fri Apr 23 17:44:50 EDT 1999 | Stefan Witte
| Hey Ya'll! | | Have any of you ever worked with one of V-Tek's "Economax" tape and reel machines? The biggest thing I'm curious about is the type of cover tape that these machines use. It's something they call P.S.A. (Pressure Sensitive Adhesive)c
Electronics Forum | Wed Feb 03 21:46:33 EST 1999 | Larry Mara
Steve, We are in the same boat--small and limeted on fund.We have a TF200 that pace is letting us demo, seems like good tool that we can add to as we need to.We are going to buy one.Great