Electronics Forum | Wed Apr 11 00:17:03 EDT 2001 | Dreamsniper
Hi, We got a 0.5mm pitch QFP144 from Altera with the below lead width specs. min. lead width = 0.17mm nominal = 0.22mm maximum = 0.27 What's the best pad or land width for the above? This is what our designer used. Land Width = Component Lead Wi
Electronics Forum | Wed Mar 25 17:11:20 EST 1998 | Mcox
| We are having some problems with "drawbridging" on 0805 film capacitors. | We have already reduced the pad width from .050" to .040" based on input | from vendor. Defects appear to be random as far as location on the PWB and direction | of placem
Electronics Forum | Wed Jul 25 13:29:24 EDT 2007 | realchunks
Hi Lloyd, Homeplates will get rid of solder balling. They are only recommended "backwards" for 0402 or smaller (Points point away from each other). If you do this, you will have a full pad width of paste on the pad for the part to stick in. Obvio
Electronics Forum | Fri Dec 17 16:07:07 EST 1999 | Alex B
Hi, C.K. Let's assume that your stencil's thickness is in a range 4-6 mil or by other words the height of the solder paste on a pads is the same (close enough to reality) Therefore, for pad's width more than 20 mils(as well as pitch between pads) th
Electronics Forum | Tue Oct 10 20:14:01 EDT 2000 | Dason C
Hi! CJ. Please advise what is your pitch size ie 15.7 mil or what is your capabiliy can you build the board with pitch 15.75 mil (please note that the actual dimension of the package is 0.4mm), and how many lead on the package. The pad width of Ind
Electronics Forum | Fri Jul 08 13:09:25 EDT 2011 | joekirin
Thanks for all the input guys! After trying to figure this out in our smt process, we have discovered that the board house did not meet the required pad width for the fine pitched ICs when making the bare boards. Our stencil was cut out to fit the p
Electronics Forum | Tue Jan 30 15:30:17 EST 2001 | dason_c
Please check what is the actual pitch size. I found some of the designer use 15.7 mil pitch and no accumulate ie 15.7, 15.7 and 15.8...... Also, I recommended the pad width should be 10 - 11 mil for 0.4mm pitch. You can open the 10 - 10.5 mil aper
Electronics Forum | Tue Jan 30 21:14:26 EST 2001 | davef
Suggestions are: * Limit pad width to 0.008" [0.2mm] * Use IPC-7525 Stencil Design Guidelines * Avoid Type 4 pastes, if you can * Slow down your print head to 0.63"/sec [16 mm/sec] * Consider the suggestions on printing by rpereira in the past
Electronics Forum | Wed Sep 24 04:18:12 EDT 2008 | gang
we have some problems in soldering joints such as insufficient solder and misalignment on some RC0402 and CC0402,i don't have a pic here. our SMT enginner doubts the PCB land pattern is at the fault.here is what we measured results.pad length:0.9mm,
Electronics Forum | Thu Aug 27 13:46:42 EDT 1998 | Rob Williams
General Question to anyone. If you were to go out and build the ideal stencil for pasting boards, what would be the best way to build a stencil? I have some boards that have 19.7 mil pitch parts and the pad width is 10 mil. The length of the pad
