Electronics Forum | Wed Nov 07 18:37:27 EST 2001 | steven
sometime hand solder can cause also. no necessary have to be paste n reflow.:) now i'm facing bridging on 0402 components pads. any suggestions on spacing distance as we're going to re-design the pcb.
Electronics Forum | Wed Nov 07 11:56:44 EST 2001 | mparker
Pad spacing is just one element to consider. Your pad spacing is determined by the pitch (center to center distance between the leads). There are several good resources to find the appropriate pitch per device. Search the archives here or refer to th
Electronics Forum | Mon Aug 28 17:54:59 EDT 2000 | Steve Thomas
We're trying out 0603 packages on some 0805 footprints (at this stage only on some test boards) since our vendor tells us the 0805's are going to be getting harder to get, and more expensive to pay for. I understand the IPC footprint for the two is
Electronics Forum | Thu Dec 08 17:43:48 EST 2022 | stephendo
A company I used to work for used hockey pucks.
Electronics Forum | Wed Sep 21 08:43:46 EDT 2005 | kmeline
We are having problems with a 1210 cap moving as far as a 1/4 inch from its pads during reflow. We have verified the placement before reflow. They will tombstone some of the time. There are smaller and larger parts around this location and none of th
Electronics Forum | Mon Apr 01 12:07:25 EST 2002 | slthomas
* What material are you using? Loctite 3609 * What is your cure profile? In excess of the 90-120 seconds at 150C that Loctite recommends. * Dot dimensions and tip? 27g. conical tipped needle for the 0603's. I started with a 14 mil dot which loo
Electronics Forum | Wed Sep 21 18:09:03 EDT 2005 | PWH
We've had parts jump off pads on occasion due to panels or boards that are restricted in a carrier during reflow. The boards/panels expand and the restriction causes them to warp thus popping parts around during cool down. Doesn't sound like your p
Electronics Forum | Wed May 07 01:50:03 EDT 2008 | andrzej
We have received in one lot PCBs with defect of not wetting properly. Pads were finished with HASL but they were matte rather then shiny (attachment). For me looks like they are oxidized. Interesting is there was just top side with such defect. We h
Electronics Forum | Tue May 23 17:09:14 EDT 2000 | John Thorup
Hi Amy You can find these items any number of places. Try Circuit Technology Center www.circuitnet.com 978/372-5700 Also most distributors of Pace products carry their Cir-Kit line. John Thorup
Electronics Forum | Wed Sep 21 10:30:28 EDT 2005 | James
It could be outgassing, are there any electrolitic caps or anything else nearby that may contain air or moisture? You could try baking the parts before use.
PCB Electronics Manufacturing Automation Software for EMS, OEM & ODM manufacturers. Over 3000 customers worldwide!
116A Research Dr.
Milford, CT USA
Phone: (888) 486-4246
