Electronics Forum | Wed Apr 07 11:36:41 EDT 2004 | stefwitt
Your machine will have to have a reference position. From this reference position, you determine all other machine positions. If the camera is attached to the head, you could place a glass slug and measure camera-nozzle offset, by placing the slug w
Electronics Forum | Fri Apr 06 22:40:24 EDT 2007 | oldsmtdude
After thinking some more: Feeder offset is usually an averaged number... If feeders get erratic feeder offset goes wacky. Nozzles don't seal, components slip and vision isn't getting the true pick position. And worse they may move again post vision
Electronics Forum | Tue Feb 07 05:41:20 EST 2012 | ngineer
I've got an issue, i can't seem to figure out. I think I need to apply a global offset to all my placements for some reason, and I would like to know why, before I do it. nozzles work, picks seem ok, but the placements are off by about 1/2 the widt
Electronics Forum | Tue Nov 01 18:00:07 EST 2005 | PWH
The front nozzle plate arm had a build-up of grease and material on the roller plate that is closest to the linear bearing. This material caused the nozzle plate to be lower than normal; therefore it was not able to push the nozzle all the way to th
Electronics Forum | Sat Mar 11 07:33:52 EST 2023 | klauss
There's two kind of nozzles with different dimensions we use. One of them works good but the another one gives a head problem sometimes. The head picks the nozzle and gives the vacuum error despite the camera recognize it. So i make another head pi
Electronics Forum | Mon Mar 13 08:59:21 EST 2000 | Jeff
Jeff, We do not use push up pin. The nozzle pick-up and placement heights are checked many times. We are looking for wich component can break the nozzles. Thanks for your help, Jeff.
Electronics Forum | Mon Mar 13 08:59:21 EST 2000 | Jeff
Jeff, We do not use push up pin. The nozzle pick-up and placement heights are checked many times. We are looking for wich component can break the nozzles. Thanks for your help, Jeff.
Electronics Forum | Sat Dec 06 12:38:42 EST 1997 | Tom Gaffney
I am interested in any solutions for incorrect nozzle rotations supplied to the HDPG-1 by Panapro. I also wondered if there is a rule of thumb for glue dot diameter vs. nozzle ID.
Electronics Forum | Tue Oct 31 23:46:12 EST 2006 | fastek
Which nozzles are coming up NG on the large camera? If it's the smaller ones, don't worry about it. Those nozzles don't use the large camera anyways. Be concerned if the small nozzles are coming out NG on the small camera.
Electronics Forum | Tue Feb 11 01:44:16 EST 2020 | SMTA-Deepak
Need to know technically which nozzle cleaner is suitable Ultrasonic or Jet Spray nozzle cleaner ? Thanking you in advance .