Electronics Forum | Thu Apr 22 08:42:40 EDT 1999 | ADRIANO FERNANDES
I would like to known what�s MESH SIZE mean in the solder paste specification ?
Electronics Forum | Mon Jan 03 14:00:06 EST 2000 | John Anderson
Has anyone had luck with 0201 cap board design, solder printing and reflow? IPC-SM-782 does not provide much help. I am particularly interested in attach pad design, stencil aperture design and thickness, solder paste (mesh, metal content, etc.), and
Electronics Forum | Tue Nov 30 11:09:16 EST 2004 | fcox
Mesh opening size may be a factor in whether or not the paste will pass but only in very fine line deposition. Generally speaking, the printed line width and deposition thickness determine what mesh to use. The paste supplier will be able to tell you
Electronics Forum | Fri Dec 10 11:19:50 EST 2021 | saberbouras
Thanks for reply, in fact, my question is how to calibrate the tool itself, it has some load spring and a gauge moving according to the tension of the mesh. I was wondering if I can make 2 different tension sets to have different comparing values, th
Electronics Forum | Thu Dec 09 14:42:28 EST 2021 | emeto
People that measure, say 4 symmetrical points() and one in the center to get the full picture. I personally see it as a NO value added activity. If stencil changes performance - replace it.
Electronics Forum | Fri Dec 10 02:42:58 EST 2021 | hello112
SMT stencil standard: measure the four corners and the middle, target value is 26N/CM or more
Electronics Forum | Fri Jun 14 14:32:05 EDT 2002 | davef
There is no real reason why you shouldn�t use your current paste. Paste for printing usually is a coarser mesh than paste for dispensing. Dispensing paste is more expensive, because of the mesh and the packaging, but that doesn�t matter now. Compa
Electronics Forum | Thu Dec 20 12:05:46 EST 2007 | realchunks
Not you Steven. Blanket comments like "Double pass printing for solder paste is not needed and will cause defects. Redesign your stencil thickness or aperture sizes, change your paste mesh size or type, go to 45 degree blades." are so way off base.
Electronics Forum | Thu Dec 09 14:04:13 EST 2021 | saberbouras
Hi all, I have a GRUNIG G-CHECK tension measurement tool, I need to prepare a calibration report internally. https://graphcom.gr/product.php?lang=en&id=128 Measuring range between 7 and 50 N/cm Thanks for sharing any useful calibration instruction
Electronics Forum | Thu Apr 22 11:44:30 EDT 1999 | Chrys Shea
| I would like to known what�s MESH SIZE mean in the solder paste specification ? | | Check out the thread from 4/14/99 on solder FINES vs. solder balls. The info you're looking for is in there.