Electronics Forum | Fri Jul 09 18:36:48 EDT 2010 | rway
We don't use flex pcbs but have the same issue here. Most of our pcbs are HASL finish. I have looked at silver and gold immersion and both look really good under my color camera on my AOI. However, gold is more pricey. There is no additional cost
Electronics Forum | Sun Dec 15 22:31:43 EST 2002 | craigj
Has anyone heard of vias cracking (barrel from pad) when being wave soldered. Was told this was a big problem by contract pcb designer, he always tent vias because of this. The reason was that the solder filling the vias caused stressing and then sep
Electronics Forum | Wed Sep 27 14:07:36 EDT 2006 | markhoch
I understand that most PCB Repair kits do not contain lead. (Being "RoHS Compliant" and being "Lead-Free" are two seperate things.) I'm just looking for a kit that has been deemed "RoHS Compliant" by the manufacturer, and labeled as such to show "Due
Electronics Forum | Wed Dec 03 06:04:10 EST 2014 | spoiltforchoice
Manual placement aids are often very similar, I would suggest it is quite difficult to tell them all apart. Most of them include some kind of carousel for bins of loose parts and have the option of a few tape "feeders". If you are building small volu
Electronics Forum | Mon Aug 18 12:02:18 EDT 2003 | russ
It all dependes on the de-paneling method. V-score - .100" is probably to thick for manual seperation. There are machines that I believe can cut through a V-Score up to .125" or greater Breakaway tabs - .100" is getting to the limit when doing t
Electronics Forum | Sat Sep 23 15:13:40 EDT 2000 | Francois Racine
Hi Sophia, I`m responsible of SMT line and we solved this problem with a complete automatic solder paste printer machine. In the past we had problem with off alignment and solder height too.... at that time we used a semi-auto printer machine and w
Electronics Forum | Wed Apr 27 23:23:18 EDT 2005 | pdeuel
It was a resonant frequency that brought down the Narrows bridge. Memorex can shatter a wine glass with resonance. Ultrasonic washers use frequency to do what they do. If anything on the pcb has a length width or mass that resonates at the washers fr
Electronics Forum | Mon Nov 26 14:49:20 EST 2001 | mparker
1. The formula for cubic area (LxWxH) applies to get the expected volume target value. Caution- do not assume the pad surface square are is correct for the part. Do consider the footprint of the device beign placed and its solder requirements to cre
Electronics Forum | Wed Feb 13 19:32:02 EST 2008 | daxman
Greetings everyone. We are currently doing some experimentation with solder paste printing over ground planes. In this application, the entire perimeter of the PCB is a ground plane. It's about 4mm wide and wraps around the whole PCB; There is no so
Electronics Forum | Mon Feb 27 17:08:08 EST 2006 | barryg
we here are setting up our lead free process. Was curious about how others handle these issues. 1) Do you physicaly segregate leaded from non-leaded (different storage areas, shelving) for part storage? 2)Do you have a seperate board washer just for
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830