Electronics Forum | Thu May 05 19:13:33 EDT 2016 | darby
Thanks Sr. If you have zero tolerance for simul pick up in your component files then you will not have simul pick up due to variances in your head offsets. So you are saying that on your Juki you run a tolerance for 0201? All other head positions at
Electronics Forum | Thu May 05 07:58:35 EDT 2016 | cyber_wolf
Not sure what you mean. 0201's and 0402's are both on 8mm feeders. Juki's will do simultaneous picks an all 8mm feeders no matter the component size. Your feeders need to be maintenanced and calibrated to reliably pick 0402's and 0201's. I hav
Electronics Forum | Wed Aug 27 13:49:02 EDT 2014 | jimmyboz
In that case, please consider one block skip mark, the same first sequence for all programs, view some feature of the X-Y table, not the PCB, that way, its just a habit. I will look into preventing advance pick, not sure if it is possible.
Electronics Forum | Wed Aug 27 16:08:51 EDT 2014 | fuji_user_2014
Alright, thanks for the fast reply
Electronics Forum | Mon Aug 25 16:14:59 EDT 2014 | dman97
In Fuji flexa, under the machine configuration tab. Panel and Board mark reading order should be set to SKIP MARK. (this only works if you have the skip mark active in your fiducial list)If it is set to FIDUCIAL MARK, then the machine will ALWAYS pic
Electronics Forum | Wed Aug 27 12:15:15 EDT 2014 | jimmyboz
I understand what you want, I do not however, understand why? I have checked some documentation and found nothing. If I know why, I might try harder for a solution. It doesn't seem like time is crucial, else you want to pre-pick. Two easy ways ar
Electronics Forum | Tue Aug 26 09:13:34 EDT 2014 | fuji_user_2014
Thank you, but as I said before, is there a way to do this WITHOUT adding skip marks? We need a global setting that will affect all our existing programs.
Electronics Forum | Wed Aug 27 13:59:10 EDT 2014 | jimmyboz
Or else, as Dman may have been pointing to, duplicate the first fid sequence, and use it as the block skip mark, if found, then the next sequence is the fid it already found as a block skip mark....
Electronics Forum | Thu May 05 01:50:44 EDT 2016 | darby
Dear Forumites, It's been a while, but I have a question. I was recently asked to provide a scenario on capacity if we retired two older lines and replaced with a new line. My capacity figures were based on real time production over a period of six
Electronics Forum | Fri May 06 08:27:38 EDT 2016 | kahrpr
We have Samsung and havehad no problems with simultaneous pick ups with 201s 0r 402s. the feeders are durable and do not need much repair especially the sm feeders. The SME feeders have not been out as long so we will see so far so good. As with all