Electronics Forum | Mon Jul 07 22:34:29 EDT 2008 | davef
Me?? Six figures?? You're the one cooking those expensive Pop-Tarts, mame.
Electronics Forum | Wed Jul 24 12:26:35 EDT 2013 | cyber_wolf
http://www.youtube.com/watch?v=JWUJtmgh55M
Electronics Forum | Tue Apr 15 16:16:25 EDT 2014 | rway
Can you attach a photo of said component? Reese
Electronics Forum | Tue Apr 15 16:26:38 EDT 2014 | emeto
Here is one from X-ray. It is basically two BGAs one over another.
Electronics Forum | Wed Apr 16 14:55:05 EDT 2014 | emeto
Hege, The package is already built.
Electronics Forum | Tue Mar 14 14:34:02 EDT 2023 | joeljacobo
Hi, I think they are a bit of both. When they pop the bubbles something like a foam is generated.
Electronics Forum | Tue Aug 25 10:38:03 EDT 2009 | grahamcooper22
Hi Sergey, Do you know the Moisture Sensitivity Level of the component ? This is normally recorded on the DRY PACK that the device comes in. It is not unusual for a device to POP CORN and still work in test. It depends how much damage there is to th
Electronics Forum | Fri Apr 11 12:42:29 EDT 2014 | emeto
Hello all, does any body place PoP parts? We are running them through a regular process(paste place reflow) and we don't have good rates on these. Mostly we observe opens at the sides of the part. We are thinking to purchase a flux feeder, but I wan
Electronics Forum | Mon Jul 08 11:53:40 EDT 2002 | yngwie
Hi Guys, We prints solder paste on via hole as the holes are used as the test points. This is a clean process. In normal production, upon completion of a primary side, board will proceed to secondary process immediately. The problem happened when
Electronics Forum | Thu Jun 04 09:29:21 EDT 1998 | Chrys
I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after and r