Electronics Forum | Fri Feb 29 09:13:46 EST 2008 | bobpan
I have seen this on our assemblers look in the machine and check to be sure there is no obstruction IN the down flag sensor located on the bottom of the front transport assembly.
Electronics Forum | Thu Feb 14 17:36:28 EST 2013 | dontfeedphils
I'm trying to get an '07 Accuflex into production and I seem to have a small problem. When trying to calibrate the zero pressure point on the squeegees I drive them down until they are touching the stencil and once they touch the stencil they run ou
Electronics Forum | Tue Jul 19 09:45:51 EDT 2005 | cyber_wolf
I have seen this problem on Mydata machines before. I am very sure that your missing paste is being caused by the placement machine. Check these things : 1. There is a small white check valve on the pressure side of the vacuum pump. Make sure it is
Electronics Forum | Sat Nov 09 19:37:52 EST 2019 | kylehunter
> the issue is the calibration. What you set it for > has to match what it actually reads or you get > the error screen at the end of every pass. If > you go into the maintenance menu ( using the key > next to the system button )
Electronics Forum | Wed May 16 18:09:09 EDT 2018 | dleeper
Does the table move under the stencil than just sit there doing nothing? there is an optical sensor in the machine near the end of travel, sometimes solder past or dirt gets into it preventing the contact from being made. Another issue I vaguely rec
Electronics Forum | Fri Mar 18 15:02:07 EST 2005 | pmd
Please clarify, Z axis gears (Blades)? The MPM head I believe is what your are asking is driven up and down via a lead screw. The machine gets the zero point from the "HAT" tactile sensor in the table nest. When squegees are installed the blades are
Electronics Forum | Fri Sep 23 08:27:28 EDT 2005 | siverts
The 7 spindle Flex jet head, can only pick max 7 comps. from the GSM base machine in a single operation, not from the shuttle. The Flex jet head is faster in z-axis and will also use the OTHC (On The Head Camera) to inspect most of Your smaller comps
Electronics Forum | Fri Sep 04 02:09:03 EDT 2009 | sachu_70
Hi Walter, Do you refer to a sprayfluxer operation? The problem seems to be a parameter setting issue. 1. Ensure the wide angle spray reaches PCB with optimum jet pressure. You could pass a glass plate to understand flux coverage and view Jet pressur
Electronics Forum | Fri May 16 13:43:29 EDT 2003 | T.Vick
Yukim, Just another thought (way off the solder paste trail that you've been on so far)....Are the parts similar in thickness? The 4796 and 4797 HSP's have a closed loop function that compensates for variations in component thickness based on fe
Electronics Forum | Thu May 09 12:06:06 EDT 2013 | pbarton
We run Zipatec 460's also. I presume that you are running Nitrogen? We have found that if the Nitrogen flow rate is too high into the conical nozzle collar it can be sufficient to disrupt the smooth flow of the solder as it runs down the wettable o
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723