Electronics Forum | Mon Sep 29 11:44:39 EDT 2008 | manishc
We r facing less soder problem with qfp,using 4 mil tencil and lead free paste,tried out different combinations of reflow profile,can anybody suggest?
Electronics Forum | Thu Oct 02 08:26:41 EDT 2008 | rway
We had similar issues until we went to a 6 mil stencil thickness.
Electronics Forum | Tue Sep 30 14:06:04 EDT 2008 | realchunks
What pitch? You can go 5 mil or even 6 mil stencils depending on your screen printer. Also what do you consider "less solder"? What defect are you having. Remember on a QFP you use the heel filet to determine proper solder joint - not the toe.
Electronics Forum | Mon Apr 17 19:30:27 EDT 2000 | Boca
All of the above is good stuff. To add, I have seen this several times if the assembly is wavesoldered. Heat from the wave can partially reflow the top side SM solder joints and weaken them. To test, check joint strength before wave and then after
Electronics Forum | Tue Apr 11 14:59:05 EDT 2000 | Glenn Robertson
Jeremy - What's the process flow on these modules? Are they wave soldered? What is the board finish (ENG, HASL, etc.)? Glenn Robertson
Electronics Forum | Mon Sep 29 14:47:15 EDT 2008 | davef
Let's narrow this down. Questions are: * Are you putting the proper amount of solder in the board with your stencil print process? * If you are putting the proper amount of solder in the board, where is the solder going? Pick one and then fill-in th
Electronics Forum | Sun Aug 15 14:56:03 EDT 1999 | Dean
| One of the DFM suggestions I've seen is to remove the solder mask web, i.e. the mask between pads on 20-mil QFP devices. The rational is that if the mask is thicker than the pad the mask can prevent the stencil from making intimate contact with th
Electronics Forum | Mon Aug 16 04:34:54 EDT 1999 | Earl Moon
| | One of the DFM suggestions I've seen is to remove the solder mask web, i.e. the mask between pads on 20-mil QFP devices. The rational is that if the mask is thicker than the pad the mask can prevent the stencil from making intimate contact with
Electronics Forum | Mon Aug 16 04:47:04 EDT 1999 | Charles Stringer
| | | One of the DFM suggestions I've seen is to remove the solder mask web, i.e. the mask between pads on 20-mil QFP devices. The rational is that if the mask is thicker than the pad the mask can prevent the stencil from making intimate contact wit
Electronics Forum | Mon Aug 16 16:54:57 EDT 1999 | Scott Cook
| One of the DFM suggestions I've seen is to remove the solder mask web, i.e. the mask between pads on 20-mil QFP devices. The rational is that if the mask is thicker than the pad the mask can prevent the stencil from making intimate contact with th