Electronics Forum | Thu Dec 08 13:05:51 EST 2005 | bobpan
In the scp.ini file you either check light control on or off.....i am not sure where you are putting numbers in at. You can use a slim feeder if it will fit onto your feederbase and if you do....you wont need the 2mm option turned on. What version o
Electronics Forum | Fri Dec 16 12:50:34 EST 2005 | derengmao
I do have all tools for calibrate. The 4" plate is looked like for down-look camera. The big nozzle is for up-look camera. I did all the procedure in the handbook from Traning Center System from Quad. The up-look camera does see the nozzle, and passe
Electronics Forum | Mon Jul 09 18:29:19 EDT 2012 | btipcb
I have gotten to what I hope is the last step before I can start running product. However, I have and keep receiving an "Invalid Place Position X" error in three steps of the placement program. I have verified that the camera can indeed find these
Electronics Forum | Sat Oct 22 14:42:28 EDT 2005 | bobpan
we had a special nozzle made and used the new quad 0402 feeder and the machine didnt miss a part.....but its probably best only to use 1 head to pick the parts because of the z being not 'perfect' between heads and thats where you would have problems
Electronics Forum | Wed Dec 07 12:56:27 EST 2005 | bobpan
If you are referring to having the control knob on the head for the lighting or controlling it through the software... then...version 6.0 works for both. Make sure you go into scp.ini and turn on\off light control. For 0402 parts......you must have
Electronics Forum | Mon Dec 12 14:05:45 EST 2005 | derengmao
I tried to use the Fixed Camera to inspect TSOP, however, I got either "UPPER SIDE END PIN ERROR", or "Missing Group:1". I have never had a parts getting recognized. I adjusted all parameter possible: Light, size, width, length. By using Dispaly Par
Electronics Forum | Thu Dec 15 07:55:24 EST 2005 | bobpan
Calibrating the fixed camera (this is the camera that is mounted in the feeder base), I dont recall there being a procedure for calibrating it. You need a special nozzle and a plate that sits on top of the camera and you calibrate it in the system se
Electronics Forum | Tue Jul 30 23:51:06 EDT 2019 | rob1
Have you tried entering "DEK" as the password?
Electronics Forum | Tue Nov 25 18:30:36 EST 2003 | bman
I think it might just be zcr. At least that is what it is for our oven.
Electronics Forum | Mon May 15 16:30:29 EDT 2023 | daniel_stanphill
I have seen them just be 0