Electronics Forum | Tue Nov 20 05:56:41 EST 2018 | deanm
Precision Placement Machines supports Quad.
Electronics Forum | Mon Jul 08 12:25:55 EDT 2019 | bobpan
It sounds like someone needs to check the servo tuning. Bob
Electronics Forum | Tue Feb 09 14:53:50 EST 2021 | jamesn
Thank you bobpan much appreciated I will give it a go Regards James
Electronics Forum | Wed Oct 25 21:39:16 EDT 2023 | heinar
Hi, i not found bios battery...
Electronics Forum | Thu Oct 26 16:16:40 EDT 2023 | heinar
Thank you!
Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn
Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier
Electronics Forum | Fri Jul 10 10:42:58 EDT 2009 | tronteq
Hello, I can offer training, service & support on the Quad QSP-2. Up until November 2008 I was employed by Tyco Electronics who aquired Quad back in 2000. I have set up my own company with Tyco's blessing to offer support on their behalf in Europe. T
Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Wed Feb 27 12:38:49 EST 2002 | stmerkt
Tyco has recently completed development work on the ThinPRO feeder. This feeder provides exceptional performance for 0201 and 0402 applications. The feeder is compatable with the IV-C, QSV, QSX, QSP-2, and APS platforms.
Electronics Forum | Wed Jun 17 19:44:31 EDT 1998 | Eldon Sanders
Rob, I think the change over on the Quad QSP2 is about as easy and fast as it can get without swapping out the feeder bases. In a high mix environment I think it is worth looking at. Regards,
