Electronics Forum | Mon Jul 23 11:28:01 EDT 2001 | jseagle
If you don't want to use a sponge try the Hakko 599 Tip Cleaner. It uses a brass "sponge" (no H2O) to clean the tip. Also, the tips seem to last longer due to no water, which causes the tip and heater to rust.
Electronics Forum | Mon Jul 23 11:40:48 EDT 2001 | jseagle
If you don't want to use a sponge try the Hakko 599 Tip Cleaner. It uses a brass "sponge" (no H2O) to clean the tip. Also, the tips seem to last longer due to no water, which causes the tip and heater to rust.
Electronics Forum | Mon Jul 23 11:42:25 EDT 2001 | jseagle
If you don't want to use a sponge try the Hakko 599 Tip Cleaner. It uses a brass "sponge" (no H2O) to clean the tip. Also, the tips seem to last longer due to no water, which causes the tip and heater to rust.
Electronics Forum | Mon Jul 23 11:47:05 EDT 2001 | jseagle
If you don't want to use a sponge try the Hakko 599 Tip Cleaner. It uses a brass "sponge" (no H2O) to clean the tip. Also, the tips seem to last longer due to no water, which causes the tip and heater to rust.
Electronics Forum | Wed May 30 11:28:26 EDT 2007 | vikkaraja
I have replaced few of those, on 1500, 1700, and 1809EXL. It should not take you more than couple of hours. Only problem I do see you running into is maybe rusted/welded screws for the elements from heat.
Electronics Forum | Sun May 17 03:44:30 EDT 2020 | dunks
Hello, has anyone had issues with uncoated ferrite smd inductors corroding/rusting from di water wash?
Electronics Forum | Sat Jul 08 02:21:40 EDT 2023 | unsung
I did clean the gold strip and black encoder box pretty good it took me a few trys but it work ( it did had rust on the machine from the rain I guess... from being out side for awhile)
Electronics Forum | Thu Aug 17 08:49:11 EDT 2006 | Chunks
I would imagine your system is either stainless and/or some form of plastic. The water can rust but I doubt your machine has any metal that would be affected by it. You may want to double check your spray cell as well. We have been running water s
Electronics Forum | Tue Jun 26 07:15:06 EDT 2007 | zanolli
I've used PVC, black iron and copper: Forget PVC, too dangerous as joint strength completely reliant on glue, black iron will rust and accumulate debris over time, copper is the best but now because of very high Cu commodity prices could very well be
Electronics Forum | Mon Aug 31 13:04:13 EDT 2009 | bandjwet
We have tried air drying (using shop air) our SMT stencil post sonic cleaning. This technique only "pushes" the water droplet around to the other side of the stencil. Air drying causes the "Invar" stencils to rust as the water sits on the stencil sur
