Electronics Forum | Tue Feb 04 19:53:50 EST 2003 | joeherz
Hello All, I've come across this machine and have no experience with Streckfuss other than the little radial "trim only" unit. Does anyone own one of these? Good, bad, ugly? The one I found is going for $2.5k and has a good selection of dies.
Electronics Forum | Tue May 31 11:43:27 EDT 2005 | ??
Worn out is all relative. If the machine is in a factory on a dirt floor with no air-conditioning.....it could be "worn out" after 1000 hrs. but then again....if it is in a well kept building with the proper maintenence........10000 hrs could be fine
Electronics Forum | Tue Aug 25 12:08:12 EDT 2020 | dontfeedphils
On a small, single stage RPS machine I was going through a dewar (not sure on the capacity differences between what you're using and a dewar) every 6-9 business days running normal 8 hours shifts. Side note, I'd suggest trying out SN100C alloy over
Electronics Forum | Tue Nov 30 06:33:44 EST 2010 | jmw
If you are using the upward camera then you probably have to put in a placement offset for each head. This only effects upward camera placements...not quadalign. This is located in: 1. machine-calibration-camera lens 2. Choose upward camera2 under "
Electronics Forum | Tue Sep 08 13:33:07 EDT 1998 | Brad Kendall
For pick and place, I have worked with the Zevatech machines and Philips machines. Both are great machines. The Zevatech will give you greater speed and still offer great accuracy and repeatability. Don't let the belt drive stuff scare you, it sta
Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
Electronics Forum | Wed Aug 05 18:06:34 EDT 2020 | smittym
So I have a old TpSys system running on a TP9-2U and I can't get the initializing hardware when I boot the unit. Once the program loads the computer freezes if I select any of the drop menu items. I can however get it to initialize if I go into Servi
Electronics Forum | Fri Sep 05 09:33:32 EDT 2014 | cflames17
It could very well be the Safety Relay located inside the ELMO PSU (Bottom left in computer cabinet). I just had the same problems on 2 MY9's within 2 months apart. the Part cost around $700.00 from Mydata (Now Mycronic). These fail commonly with old
Electronics Forum | Fri Sep 01 05:29:01 EDT 2017 | mona0312
Hi, Recently, i found a company called "jlcpcb". It’s very cheap 10pcs boards. 1.2mm thick, 1-OZ copper, 6/6-mil outer (0.1525mm) just cost $2 Cheap price and lots of options regarding board thickness, colour, etc. None of my boards have ever had a
Electronics Forum | Wed Aug 26 20:52:15 EDT 2020 | stephendo
One thing about liquid N2 is while it is safe, only let trained personnel near it. I believe if someone got their hand frozen on the side, it is not coming off until the dewer is completely empty and warmed up. And make sure management understands