Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Fri Feb 04 01:31:44 EST 2011 | fujiphil
Possible cause is the Middle Loading Sensor. Check the ML flag. Also, this problem occurs when the z-axis base slips. Need to level the base and re-calibrate z-axis origin.
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Thu Jun 26 05:07:19 EDT 2014 | bobpan
On the older machines if the z-axis has springs on them sometimes they get weak and when you open the door the z will not stay up. Before closing the door manually push the z up if they are dropping down then enable the motor power. If this is the ca
Electronics Forum | Thu Jun 26 08:11:15 EDT 2014 | leemeyer
I have 2 Meridian 1010's sitting in the back of my shop. I also bought used and never was able to get them working reliably. I hope you have better luck. If you need any parts keep me in mind.
Electronics Forum | Mon Jun 30 14:44:05 EDT 2014 | guts1872
Haven't had a chance to check this out yet. It ran all day Thursday with no trouble, then we were off for 3 days. Doing a changeover now so will try this next time it acts up. Thanks for your reply.
Electronics Forum | Wed Jul 09 11:00:47 EDT 2014 | guts1872
PC : A3005 I2 8 3326 Can anyone make sense of this?
Electronics Forum | Wed Jul 09 11:06:58 EDT 2014 | guts1872
PC : A3005 I2 8 3326. Can anyone make sense of this? Trying to add attachment but can't seem to get there.
Electronics Forum | Wed Jul 09 12:23:45 EDT 2014 | guts1872
We have cleaned the encoders even though they look pretty clean. The function clear doesnt have any effect on the machine while it is in this state. Have not checked the mag tracks but will give it a look.