Electronics Forum | Mon May 04 14:24:12 EDT 2009 | jimmyboz
Ok, So, If all the servo amps on H1 remained on H1 and the amp you changed is on H2, I have to guess the shifting on H1 is unrelated to the servo prob. Is the shifting unsolderable? if it just looks bad but will reflow, it may have been occurring f
Electronics Forum | Fri May 01 22:22:20 EDT 2009 | rodrigo
We didn't leave them swapted. They were placed in the original position until we got the replacement. What has me puzzled is that it worked for one panel correctly. I want to answer the other posts here too ... SA-6 is for Z2 The amp showing 7 is f
Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
Electronics Forum | Thu Oct 04 09:32:23 EDT 2007 | dilbert
Linear drive uses linear motors that have no moving parts, strictly a coil over magnets. "Rack and Pinion" as you call it uses AC servo motors that are driving belts and pullies The linear motor has no moving parts and is faster but generates a lot
Electronics Forum | Thu Aug 17 13:55:45 EDT 2023 | markhoch
I think we need more information. Is it moving at all? Does it move to a reference position and then stop before returning to the home position? Have you verified that all sensors are working correctly? Does the machine use stepper motors, motors & e
Electronics Forum | Thu Mar 25 07:59:57 EDT 2010 | fredc
Hello Rodrigo, My expierence is with metal cutting machine tools not Fuji placement machines. That said there are a several of areas to look at. #1.Interference on your C axis travel, look for scrape marks or something dragging on the drum. #2. Tigh
Electronics Forum | Fri Feb 10 12:21:20 EST 2023 | youngbuck
Also, tried swapping the Servo card. X7 which is the Rising table servo motor card, swapped with X8,9,10 which are all the same and same result.
Electronics Forum | Fri Apr 12 16:13:36 EDT 2002 | pjc
Dave, USI makes spray fluxers with stepper motor and servo motor controlled traverse heads that only spray on the board. Virtually no waste going up the stack. www.ultraspray.com
Electronics Forum | Fri Sep 08 11:06:11 EDT 2006 | fabio
the video and the servo motors don't start... i need a wiring diagram to make the measures... please help!!
Electronics Forum | Wed Nov 30 14:27:27 EST 2011 | bobpan
The machine has linear servo motors. It has to be VERY level. You may want to check that this is the case. If this doesnt work.....make sure the encoder scales are clean. Good Luck