Electronics Forum | Thu Aug 19 05:12:41 EDT 2004 | bernardmulcahy
Hi Russ, Thanks for the reply -- It is not a double sided board so I guess I will be doing pretty much the same process as you described. I was wondering about was the tool you mentioned -- Is this just a fixture you got made locally or some specific
Electronics Forum | Thu Aug 22 23:09:34 EDT 2019 | sssamw
Yes, you need work with supplier to see if can run pin in paste for these connectors, even do some experiments. A step-up stencil would be good for these connectors, also connectors pin size and length match with PCB hole design.
Electronics Forum | Wed May 23 10:12:32 EDT 2001 | richf
We're close to receive an assy including one VHDM connector, I'd like to receive any info to be able to place this part properly, and if possible, to know if there is any automatic equipment to place them
Electronics Forum | Wed May 23 19:07:40 EDT 2001 | davef
These installation procedues will get you started http://www.teradyne.com/prods/tcs/products/hpi/vhdm/techbull.html
Electronics Forum | Thu Aug 22 16:25:18 EDT 2019 | scotceltic
Yes, unfortunately a lot of datasheets these days do not contain the temperature resistance to determine if it can handle the PIP application. In the past I have always used a 250 C at a min of 5 sec for the material. Also, the part should have sta
Electronics Forum | Thu Dec 09 10:13:53 EST 1999 | Clifford Peaslee
Tom, Yes you were right, that file was unavailable. It has been replaced. Thanks, Cliff
Electronics Forum | Sat Dec 11 10:45:08 EST 1999 | tom terlizzi
tried again to dec 11 and it work the first time I don't have my password this time I did so maybe you have to been in a password mode thanks Tom Terlizzi aeroflex
Electronics Forum | Tue Dec 28 09:36:34 EST 1999 | Dan Woodward
Certainly automatic placement, preferably with vision system assistance will yield a more repeatable process. Process repeatability (paste deposition, connector placement, reflow cycle, etc.) will be your key to success here. Another possibility yo
Electronics Forum | Fri May 06 08:39:59 EDT 2016 | kahrpr
The first issue I see is that you have a high potential of the 402 tombstoning.
Electronics Forum | Tue May 26 22:13:15 EDT 1998 | Pat Copeland
R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommende
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, China
Phone: 0755-33578694