Electronics Forum | Mon Feb 22 10:21:58 EST 2010 | mystkldy
We did the firt 2 with no luck.
Electronics Forum | Mon Jun 10 05:05:33 EDT 2019 | pcbconnectchina
Hello! Don, I heard from SMT factory that the fixture for oven they use is durostone material, I don't if durostone is correct name translated, it is synthetic stone made of carbon fiber sheet. Best Regards Clare PCB Connect China
Electronics Forum | Mon Feb 22 10:01:01 EST 2010 | jtsyeung
Since the inductor is electro-magnetic, that means the device is composite of coil and ferrite metal. The inductor inside the reflow oven meets with blower motors which close to the inductor and generate magnetic field. With such conditions, Lawren
Electronics Forum | Sat Feb 06 16:28:09 EST 2010 | mystkldy
I have some large ROHS SMT inductors that are moving during the reflow process. I have tried adding extra solder, gluing and doing both. I don't know what else to try, any suggestions?
Electronics Forum | Thu Jun 13 12:50:00 EDT 2019 | don_julio
> A couple of caveats; The FR4 will degrade with > successive reflows and will eventually need to be > replaced. Not a big deal for low volume, but > something to be aware of. The bigger concern is > that a sheet of .125" lar
Electronics Forum | Wed Jun 12 14:00:25 EDT 2019 | proceng1
We just use scrap PCBs for Oven carriers. You could probably contact your board house and as for just sheets of FR4 to use. I've also used a binder clip at each corner to lift a board off of the mesh belt in a pinch.
Electronics Forum | Mon Jun 10 09:12:18 EDT 2019 | pcbconnectchina
Hello! Don, Yes, if the carrier is steel/stainless, it would be very hot when it comes out from oven. I heard that durostone (synthetic stone) carrier can meet your requirement, it can stand high temperature with low thermal transmission. So when it
Electronics Forum | Tue Jun 11 11:22:19 EDT 2019 | sumote
If the board is just not reaching the temps you need, you could place them in an oven to "preheat" them. When I was building a rather thick board with a copper core I had to do this. Since we were only doing small runs it was feasible, I don't know y
Electronics Forum | Tue Mar 09 07:06:42 EST 1999 | Charles Stringer
| | | | I need to setup an oven to run with a nitrogen atmosphere for | | boards with BGA's, but our ovens do not have the optional atmosphere monitor and controller. Is there a good way to sample and control the atmosphere without the optional bui
Electronics Forum | Wed Jun 13 17:17:57 EDT 2001 | medernach
I use BioAct SC-10 and it seems to work pretty well. The best bet is to contact your solder paste manufacturer and ask them for a recommended cleaning solvent for the flux residues... Regards, Justin