Electronics Forum | Tue Nov 09 17:38:01 EST 2010 | davef
What's your stencil thickness?
Electronics Forum | Sun Mar 04 09:53:00 EST 2012 | eadthem
What i have on the original 2 problem boards is the parts next to it are SOIC8 and placed using a 125F(.125" dia) 1 of witch is close and we have to Z zone it to place the SOIC last, the others have more than .02" clearance on all sides. The other
Electronics Forum | Mon May 04 18:55:21 EDT 1998 | Dave F
| Looking to buy used or new tubes, that will fit an SOIC-16 | Need these tubes ASAP. We need to bake these parts and drypack. | Please email or call if you can help. | Eric Jenkins | 801 956-0897 Eric: A source for metal IC tubes is: Perfection Pro
Electronics Forum | Thu Aug 16 04:35:10 EDT 2012 | craigweir
Can anyone advise on the risks involved in using a (previously soldered) component, in this case an 'SOIC8', as pick-up area for subsequent pick/place operation of sub-assy to larger motherboard ? The sub-assy in question would be a small outline(25
Electronics Forum | Mon Aug 29 19:41:07 EDT 2022 | assuredtech
I'm not positive on the SFN3 but I have three of the MBF80-SOL which might be more inline to what you are after for 8mm package. It haa 5 lanes. It sounds like the MBF80 is... MBF80-SO/SOL 6-Lane Belt Feeder, 3 SOL, 3 SOIC. 3 SOLIC + 3 SOIC. Edward A
Electronics Forum | Tue Aug 04 12:15:33 EDT 1998 | Steve Gregory
| | | | I am looking for some design guidelines (length, width, spacing) for solder thieves which are placed behind trailing pins of wave soldered SOICs. I'd appreciate it if some one could direct me to the appropropriate reference. | | Also, has an
Electronics Forum | Wed Mar 10 13:53:13 EST 1999 | Vincent Vega
| We will wave solder a board with SOIC14 and SOIC16 parts on the bottom. It has been difficult to find any specific wave solder process recommendations from manufacturers of the SOICs. The pad geometry utilizes theiving pads on both sides to reduce
Electronics Forum | Thu Jan 10 06:41:43 EST 2002 | Dreamsniper
Okay, I've read about the pros and cons about solder paste dispensing. Now, I have a Camalot 3800 and I want to experiment about dispensing solder paste. I have a needle gauge of 25GA, 23 and 22. My pcb components are; RC 0603-1812, Size B, C and D
Electronics Forum | Fri Jun 09 17:45:05 EDT 2006 | mika
We have some problem with the Pb-free SOIC's at the UIC GSM2 on the Flexjet head camera; (seem to remember this from before, but I can't find it on this forum). The Pb-free small SOIC:s are reflecting the light differently than leaded parts and are
Electronics Forum | Thu Feb 03 13:23:30 EST 2005 | caldon
Hi Steve- We have a Glenbrook system and are pretty pleased with it....as far a value vs. cost it works great. I did have an issue with a Soic with a ground plane in the center...yes SOIC!!! The Ground plane was a heat sync that had vias for thermal
