Electronics Forum | Thu Jun 27 10:51:59 EDT 2019 | key
Good news we fixed the unit. The air pressure for the RS was not off. made a small adjustment for the in and the out. unit working fine.
Electronics Forum | Thu Mar 28 16:11:12 EDT 2024 | kingkelvin
In calibration menu - I see coarse measurement of z unit offset, z-unit offset, measure hydra camera z level, coarse adjust hydra tool offsets, and measure hydra tool lengths 1 - 8 - would it be any of these that I should run?
Electronics Forum | Thu Nov 24 16:53:03 EST 2011 | dontfeedphils
Oh wow, I suppose that would fix it huh? That's too bad that the whole unit had to be replaced, but look on the bright side, you should have a decent amount of spare hydra parts now right? haha
Electronics Forum | Mon Nov 21 21:46:49 EST 2011 | supse
Thanks Phil But the belt and spring has been changed recently. Unfortunatly we couldn't wait any longer for a solution, so we had to go for a change of the hydra-unit. This seems to have solved the matter, but I had hoped for a less expensive solutio
Electronics Forum | Wed Jun 12 09:37:13 EDT 2019 | key
We have a Dek 248 that when the table goes in it will not come out. We tested up/down sensors they are fine. The in and out sensors work in diagnostic. when we try to abort the unit the table should come out but doesn't. Any help would be great and a
Electronics Forum | Mon Apr 08 18:16:20 EDT 2024 | mistrthou
We had a Mycronic tech in adjusting rings to get us within spec. He was saying the emitter/receiver board at the top and the tubes themselves can go bad. Between that and having weak latches, we're looking at a refurbished unit. But we're rocking a M
Electronics Forum | Mon Jan 20 11:11:24 EST 2014 | fnorradd
I have an Ersa Versaflow selective solder machine (single bath) which runs via a Profibus control system. I have checked all of the settings on the inverter, and all of the connections and outputs throughout the machine, but the machine returns a 68
Electronics Forum | Sat Aug 17 05:22:58 EDT 2019 | hemantpang23
We are getting the " tz axis comm error" in our Fuji QP242 smt machine in tray unit, please help to resolve the issue
Electronics Forum | Wed Feb 28 01:10:33 EST 2024 | clpassoni
As I have two identical machines, it was easy, it really is the encoder, and as it is integrated into the motor it will be necessary to change the entire unit, or try to repair the encoder.
Electronics Forum | Fri Sep 09 03:18:48 EDT 2005 | dougs
we've found the problem, our MD went to visit the company and their tech showed him a failed unit, it wasn't one we made.
