Electronics Forum | Tue Dec 18 10:08:16 EST 2007 | bbarton
Drill a hole through the board (or the BGA) and set a thermocouple into the center of the device (in the X Y and Z dimensions) and run your profiler through the oven until you get the temp you need in the center of the BGA. Attach a second thermocoup
Electronics Forum | Mon Jul 26 12:55:34 EDT 1999 | M.L
Presently protos of micro-bgas (80i/o) pitch .030/.031 12BGA per assembly The board is a (.062, 4 layers) FR-4 using Dry film Pads .014inch Vias within footprint .020inch Vias to be filled by bottom side(solder side) only .030in dia. Force via plugg
Electronics Forum | Tue Dec 18 09:31:45 EST 2007 | rgduval
Bill, Any reflow oven sales guy would be happy to help you with a snazzy sales pitch. I also had some info from paste manufacturers when I pitched it to my boss. Essentially, I believe, it comes down to control. You may be able to get a 4-zone ho
Electronics Forum | Fri Aug 22 00:20:29 EDT 2008 | rameshr
Hai, In our process we are using the micro bga of size 13X13mm of pitch 0.45mm,after soldering process the bga found collapsed, we absorbed that the PCB land pattern of the BGA was not in array, uneven distribution of pads (area) & most of the pads
Electronics Forum | Fri Nov 09 10:37:38 EST 2007 | devajj
We have started using QFN packages in large volume and are having problems with no-solders. We are using 6mil stencil with 1x1 paste print to pad. These also have thermal pads with thru vias that we reduce the stencil aperture by 1/4. Board also ha
Electronics Forum | Sat Nov 10 23:46:36 EST 2007 | mika
BTW, The surrounded QFN fine pitch terminals should have the normal aperture reduction of 7 % in case of RoHS Senju solder paste. This works for our Telecom customer. The vias in the ground pad will be somewhat filled with solder and makes it diffi
Electronics Forum | Wed Aug 27 08:25:24 EDT 2008 | davef
We'd expect to see: * Solder starved connections at pads with large trace/pad areas. * Less reliable solder connections at pads that do not match the shape and size of the corresponding pads on the component.
Electronics Forum | Mon Nov 12 09:22:41 EST 2007 | devajj
BTW, The surrounded QFN fine pitch terminals > should have the normal aperture reduction of 7 % > in case of RoHS Senju solder paste. This works > for our Telecom customer. > > The vias in the > ground pad will be somewhat filled with solder >
Electronics Forum | Wed Aug 27 00:20:38 EDT 2008 | rameshr
Dear davef, Will u pls advice what are all the possible defects caused while soldering ( assembling ) this type of boards.
Electronics Forum | Wed Jul 14 16:59:52 EDT 2010 | swag
Solder paste on the pads will keep part aligned. If you do not use paste, you will need to apply tacky flux. You should not run without one or the other.
