Electronics Forum | Mon Jan 07 13:07:11 EST 2008 | chef
All must be cautioned when messing with acids. Of course, neutralization is required. ("ADD ACID TO WATER", says the wise mans daughter). But at what cost to do the job right? Theoretically, anythings possible. Have messed with acids for soldering an
Electronics Forum | Thu Jan 03 17:00:20 EST 2008 | davef
Recommended procedure for soldering stainless steel [Atlas Steels Australia]: * Surfaces must be clean and free of oxidation. * A rough surface improves adherence of the solder, so roughening with grinding wheel, file or coarse abrasive paper is reco
Electronics Forum | Wed Jul 26 10:42:43 EDT 2017 | proceng1
We have an array of boards that are difficult to depanel due to components being close to the edge. I want to route a space between strips (boards are 14" long x 1" wide) and have breakaway tabs like mouse bites, but the customer won't accept the ja
Electronics Forum | Thu Jul 27 10:57:35 EDT 2017 | fkn
We make pcb depaneling equipment and many of our customers do a combination of tab routed panels with pre-score in order to speed up the singulation process. If you like, I can send you a picture of an example. Regards Klaus Heimann FKN Systek Tel.
Electronics Forum | Wed Jul 26 11:47:56 EDT 2017 | proceng1
We've sanded bites before, but with these volumes, it would kill it. Thanks
Electronics Forum | Mon Jul 31 14:03:50 EDT 2017 | rgduval
Could always get a laser cutter to de-panelize with. I've always wanted one, personally...but, haven't been able to cost justify it. ..rob
Electronics Forum | Wed Jul 26 11:13:06 EDT 2017 | jdengler
It can be done and is done all the time. You need to check with your customer about this since you will not have clean square corners along the edge. If they are snapping the boards into a holder they may need the square corners to securely hold th
Electronics Forum | Wed Jul 26 11:35:34 EDT 2017 | proceng1
You are referring to the web left after the break, right? I figured it was possible, but I did some searching and couldn't find anything about it. Do you have a board or picture you could post of this?
Electronics Forum | Thu Aug 31 09:04:23 EDT 2017 | hxamalia
Hello ALL, Good day , it is Amalia from HX Circuit Technology Co.,Ltd in China, we are a prefessional PCB factory with many years. We are focusing on quick lead time for PCB with good service . please contact with me now ,thanks Email: amalia@hx-c
Electronics Forum | Wed Jul 26 11:44:55 EDT 2017 | rgduval
Check with your board house and see if they can do jump-scoring. I haven't dealt with a fab house yet that could, though, so, while it should be do-able, it doesn't appear to be super common, IMO. Alternatively, you could sand the edges after break