Electronics Forum | Fri Oct 01 14:16:15 EDT 1999 | Rick
I know there are a ton of variables that affect the overall height of a BGA after soldering to a PWB but... I'd like to know if anyone has done an analysis of (or if it's documented) as to what the pre and post reflow height dimension as measured fr
Electronics Forum | Wed Dec 11 06:34:24 EST 2019 | ameenullakhan
Hi Everyone, Reducing the top heaters around 10 deg each at last 3 zones of reflow oven. Helped us in achieved little lesser temperature at top connection of the CCGA. And we didn't face any bent. Bridging : Reducing the stencil aperture , has wor
Electronics Forum | Thu Oct 17 17:18:48 EDT 2002 | Leandro G. Barajas
Hi everybody, This is a simple posting to initiate a discussion on different ways to troubleshoot, improve, and control the Stencil Printing Process SPP in SMT manufacturing. There are many SPC, ANOVA and other analysis techniques that provide insi
Electronics Forum | Fri Apr 02 10:26:13 EDT 2010 | fishingfool
Manjunath The top camera will be used for probably 90-95% of your inspection needs. However, without side cameras that 5-10% of uninspected parts can be a real pain to manually verify. What you need to figure out is what is your product to inspe
Electronics Forum | Sat Dec 09 14:10:17 EST 2006 | fastek
Perhaps Samsung would like to become more of a top tier vendor like a Siemens and therefore it would be a good fit. Considering Samsung is the GE of Asia they could swallow up anything Siemens is in to....anything. If you're going to be the GE of
Electronics Forum | Tue Dec 10 14:10:38 EST 2002 | Randy Villeneuve
Steve, I wave solder most if not all our boards with selective wave pallets. I did not catch if the solder balls were on top of the board or on the bottom but that will make a difference on what to do to get rid of them. Pallets are good and bad. On
Electronics Forum | Fri May 28 15:01:02 EDT 1999 | Tony
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Wed Aug 01 09:36:17 EDT 2001 | Pete Barton
Jay, > > I agree with your assement and Chips on > the Quads. I once worked at a shop that had Quads > and DynaPerts(at the time) The perts were > slower(TIME) and required(EFFORT/PEOPLE) more > MAINTENANCE(more effort more people and more > re
Electronics Forum | Fri May 28 16:03:10 EDT 1999 | Jeff Sanchez
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Thu Jan 24 13:23:53 EST 2002 | Shawn
Thank you all very much for the responses. The solder is eutectic and the problem, as far as I can tell, has been around before I was here, 2+ years. The flow machine is a treiber with 2 bottom preheaters and 1 top. The solder pot temp is 500F +/-4F