Electronics Forum | Wed Apr 16 09:30:09 EDT 2008 | swag
IPC-7530 might help some but will cost you a little. We have an older OmniFlo that has a pretty good section on all that in the manual if you happen to have one of those.
Electronics Forum | Thu Apr 17 07:46:22 EDT 2008 | cyber_wolf
CK, I agree with you 100%. I mentioned this to one of my managers....... But, that is what they want. Alll....righty....then...
Electronics Forum | Thu Apr 17 12:27:56 EDT 2008 | samir
Sr. Tech: Here is a decent article by Phil Zarrow: http://smt.pennnet.com/Articles/Article_Display.cfm?Section=Archives⊂section=Display&ARTICLE_ID=80850
Electronics Forum | Thu Apr 17 20:29:35 EDT 2008 | lellis
Follow the traveller as per a engineer there shouldnt be a issue. If the engineer isnt correct the operator isnt to blame, unless they are not following the traveler or paying attention to parameters. Is the messenger to blame, who sent the message?
Electronics Forum | Wed Nov 06 19:59:39 EST 2002 | davef
Consider checking with your CC materials supplier for suggestions. It's to their benefit to help you do a good job using their product. Regardless of your current requirements, consider basing your workmanship on NASA-STD-8739.1 Workmanship Standar
Electronics Forum | Wed Nov 06 18:27:18 EST 2002 | MikeF
At this time we will be hand spraying acrylic, probably using spray cans until we decide on a spray gun or an air brush, and get one ordered. Our volume is too low to even consider an automated system. Our current requirement is on an item designed
Electronics Forum | Wed Apr 16 15:38:46 EDT 2008 | ck_the_flip
This person needs to have the "mental faculties" and a basic understanding of science, and understand concepts like flux, solder paste, time vs. temperature curves, etc. Do they have to be a metallurgist?? Of course not, but at the minimum they hav
Electronics Forum | Fri Apr 18 10:28:59 EDT 2008 | patrickbruneel
Samir, The simple solution to your frustration is: NEVER talk technical to a manager talk numbers and $$$$. I made the same mistake in the past, I wrote long sophisticated technical reports to justify change in the process and never got anything a
Electronics Forum | Fri Apr 18 09:16:59 EDT 2008 | samir
Yes, BLAME. It's a common theme in manufacturing unfortunately. Also, unfortunate, is that the PROCESS is the easiest thing to blame and often the path of least resistance to the non-technical manufacturing personnel (operations managers and line s
Electronics Forum | Sat Jan 28 16:32:58 EST 2006 | GS
Hi Mike have you already seen this link ? http://training.ipc.org/ Regards..............GS
Blackfox is the industry leader in providing IPC Certifications, Solder Training, Customized Training Programs, and Counterfeit Component Training and Certification.
Training Provider / Standards Setting / Certification / Manufacturer / Consultant / Service Provider
701 Delaware Ave. Unit B
Longmont, CO USA
Phone: 303-684-0135