Electronics Forum: trays (Page 3 of 75)

Mydata's handling matrix trays ?

Electronics Forum | Thu Apr 28 01:30:07 EDT 2005 | Marv

The Tray wagon on a Mydata can be any table width you desire, a one bay holds two trays, a two bay holds five, and a three bay holds seven. The tray wagon can be removed in about a minute flat. the TEX actually only requires two slot positions to h

Re: Dimensions of waffel trays

Electronics Forum | Wed Dec 27 21:16:51 EST 2000 | Dave F

Expanding on Dason's suggestion ... 4 Waffle Tray Size 4a www.jedec.org/download/default.htm search for "registered microelectronic carrier". 4b JEDEC Publication 95, under the CO- and CS- standards. 4c Tray manufacturers [ie, Peak, Summit, Nepenthe

Mydata's handling matrix trays ?

Electronics Forum | Thu Apr 28 11:13:33 EDT 2005 | cyber_wolf

We currently have Fuji's(IP3's included) and Mydata's in our SMT area , so training is not an issue. The reason I was thinking of an IP3 is because they seem to be available for 50K or so. We cannot afford to loose any mag positions on our Mydata's t

Recycle Matrix trays and Reels

Electronics Forum | Wed Mar 20 15:25:05 EST 2002 | angiewest

Looking for a company to recycle plastic reel and I.C. tubes. I already recycle trays with Smart Cycle (formally Semicyle). I hate to throw that stuff away. The local recycling places only recycle plastic 1 and 2. Most of the reels are 3's.

Mydata's handling matrix trays ?

Electronics Forum | Thu Apr 28 16:12:30 EDT 2005 | stepheniii

I was going to say something about being carefull to not replace part trays with full trays and to make sure where the pickup location curently is. I think we had a tray of parts drop, then there were restrictions on who could load trays. When I work

Recycle Matrix trays and Reels

Electronics Forum | Thu Mar 21 11:19:42 EST 2002 | bmulcahy

Why not go back to your suppliers and see if they will take the reels for re-use ?

Mydata's handling matrix trays ?

Electronics Forum | Thu Apr 28 08:04:45 EDT 2005 | stepheniii

I like Mydata, Fuji, and Panasonic equipment. However if you have one, I"m not a fan of mixing. I have worked with the IP3 with MTU. I found it a good solid machine. The only thing at that time was the programing. I believe they have changed thi

Re: Dimensions of waffel trays

Electronics Forum | Wed Dec 27 16:31:37 EST 2000 | Dason C

Charlie, please check Jedec Publication 95, you may found the information which you want. FYI, http://www.jedec.org/DOWNLOAD/pub95/ Rgds. Dason.

Mydata's handling matrix trays ?

Electronics Forum | Thu Apr 28 09:01:21 EDT 2005 | jdengler

I agree with Stephen. The mixing of manufacturers can be a large headache if you do not have alot of people and time to get trained on the new manufacturer. The used equipment dealers won't like this, but buying a used fine pitch placer without kn

Universal GSM dumping trays with parts still in!!

Electronics Forum | Thu Mar 08 16:00:03 EST 2001 | gsmguru

Enter A value of -1 in the Tray pickup X & Tray pickup Y fields. This will disable the automatic empty tray pickup by the machine. I would recommend getting a data sheet on the tray from the component vendor for accurate pocket & tray dimensions. Var


trays searches for Companies, Equipment, Machines, Suppliers & Information