Electronics Forum | Mon Apr 19 14:27:16 EDT 2010 | davef
Ralph Woodgate says that pump speed is the biggest driver to dross production
Electronics Forum | Sat Apr 24 08:37:07 EDT 2010 | sudhir14
HI, Can pl. provide the some detail on recomanded pump speed
Electronics Forum | Thu Sep 26 23:14:25 EDT 2013 | zsoden
We picked up this old (circa late 80s) Seho 1135 machine last year for next to nothing. It needed a bit of TLC to bring it back to working order but it's 99% working now. The only problem left is that we cannot get sufficient height from the delta wa
Electronics Forum | Mon Apr 26 09:54:59 EDT 2010 | baildl632
What type of wave machine? Does your machine have a pump speed dial? Does your machine have the ability to raise and lower the pot? Raise pot to as close as possible to the pallets/boards and make sure they can pass over the nozzle without hanging o
Electronics Forum | Mon Apr 19 11:36:10 EDT 2010 | baildl632
We installed a fixed distance optical sensor above the conveyor rail and "wired it" throught he machines terminal bus to cut the pump on only when a board was present at the pot. We also installed a timer in line so the pump would only stay on long e
Electronics Forum | Mon Apr 26 10:29:49 EDT 2010 | davef
Set pump speed so that the board is 1/3 to 1/2 immersed as it goes through the wave.
Electronics Forum | Thu Mar 30 04:42:28 EST 2000 | cpgoh
HI all, thanks for the advise.. Electrovert is being used from 7am to 7pm and we do dedross from the surface of the solder bath during lunch time around 12nn. Break Time we just sweep them to the side.. Every two week, we do the solder bath maintena
Electronics Forum | Thu Apr 15 10:09:55 EDT 2010 | davef
Dross formation rates for SnCu and SAC are roughly 2.5 times the rate for SnPb (Hwang et al., 2004) Methods for reducing dross are: * Lower pot temperature * Run pump speed slower and only when soldering * Check solder contaminants to BS219, ASTM
Electronics Forum | Tue Dec 13 06:56:27 EST 2005 | adanhn
Hi Steve, What I came up with for our Soltec Sigma 6621 is to make a stainless steel wave solder bath insert.The insert with all its components eg. impeller, Chipwave assy, pump shafts, main wave assy etc. I will send for plasma nitride coating.Afer
Electronics Forum | Thu Mar 30 11:07:41 EST 2000 | Wolfgang Busko
> the dirty patch appear seems to be a bit powdery on top of stickiness > the "harden" dirt in the solder pot or at pump are ususally "knock" out while cleaning.. is that thorough enough..? Assuming that 1) is true it might not be thorough enough. On
