Electronics Forum | Tue Nov 03 18:56:22 EST 2020 | goldendragon
All, I'd like to know what a good used wave pb-free solder machine out there? Appreciates!
Electronics Forum | Thu Jun 17 21:33:46 EDT 1999 | Dave F
| Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | for example: | | Solder Bridge | 1.verify amount of flux been aplied. | 2.verify turbulance on your solder wave. | 3.etc.
Electronics Forum | Fri Jun 18 14:24:01 EDT 1999 | Vince Whipple
Tony, I have a great one page solder defect chart I can fax you, send me an email with your fax # and I'll shoot it over to you. vwhipple@sono-tek.com Vince --------------------------------- | Does anyone know where I can find a list of things to
Electronics Forum | Tue May 17 10:11:54 EDT 2005 | russ
I would use a foam fluxer since spraying rosin will make the stickiest nastiest mess you can imagine. 18 layer board huh? You will want convection preheat, both top and bottom preheaters, preheat tunnel of at least 4-5', a chip wave, laminar flow w
Electronics Forum | Mon Jun 21 14:55:27 EDT 1999 | JohnW
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Mon Jun 12 11:07:17 EDT 2000 | Jason
after reading some other problems i can tell you that we have an electrovert wave and are using alcohol base flux with convection preheaters. also we are spraying it on...not foaming. we are using an omega wave also. thanks again...if you need mor
Electronics Forum | Tue Oct 11 14:02:59 EDT 2016 | mnorthey
We have a slider Bar on the back side of our Delta Wave. It is adjustable and slides up and down (adjusting bolt) on the back edge of the Lamda Wave to prevent this problem; keeping the trough behind the Lamda is essential as well. Along with attenti
Electronics Forum | Thu Jun 17 20:35:51 EDT 1999 | Earl Moon
| | | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | | | for example: | | | | | | Solder Bridge | | | 1.verify amount of flux been aplied. | | | 2.verify turbulance on
Electronics Forum | Thu Feb 23 10:19:29 EST 2006 | Hiram
Hi John, I have used some wave fixtures with titanium inserts. I ordered from Pentagon EMS (503)924-2747... Turnaround time and quality are excellent. Regards, Hiram
Electronics Forum | Tue Nov 28 14:02:06 EST 2006 | jsloot
I am starting to use a DATAPAQ wave analysis software on our Econopak EPK II machines. I would like to know what values you may be using for alarm conditions. I can email an example if you can help. Thanks
