Electronics Forum | Wed Jan 26 05:24:56 EST 2005 | SLVito
Morning All, I have to choice between two axial through hole machines: Panasert AVK 3 and Universal VCD Sequencer 8. I will insert axial components with 0,45 mm to 0,8 mm component lead diameter and perform jumper wire insertion in the same machine.
Electronics Forum | Mon Nov 12 06:05:15 EST 2001 | nop_e
Dear all I 'm looking the minimum X-Ray machine capability that is capable to inspect the solder joint of BGAs, Fine pitch BGA and CSP such as open, poor solder joint ,etc... What is the machine specification needed? Thank you for your advise.
Electronics Forum | Wed May 19 20:11:21 EDT 2021 | compit
I have two machines - Emerald-X and Topaz-X. I cleaned (and changed Koganei electromagnets) only in Topaz-X - Emerald-X is in very good condition :) But my Emerald-X have SF (not FNC) heads. If head 1 is OK - change the relays with head 2 and check.
Electronics Forum | Tue Jul 17 08:20:03 EDT 2012 | rosborne
Hello Jorge, We offer both a large board AOI and SPI system. It is our Spectra platform. This system can go up to 24" x 36". Please feel free to call me with more questions. Best regards, Richard Osborne North American Sales Manager - Machine Vis
Electronics Forum | Sat Oct 24 23:26:43 EDT 2015 | thefinder
Hi. Have a problem with a QSA 30 machine. show me a error at the end of set up program. CAN'T ANC OPEN and then show me on the next row message. invalid place position x. if anyone has any suggestions please tell me.
Electronics Forum | Wed May 19 20:24:09 EDT 2021 | kumarb
Thank you Michal. Very much appreciated. We are thinking along the same lines. However, we are being very afraid to even cut the official wire ties that are securing the head 1 and head 2 wiring. We have a new VAC2 solenoid in transit that will arr
Electronics Forum | Mon May 17 10:59:02 EDT 2021 | kumarb
Hi. Have an Emerald-X machine with FNC purchased refurb from Assembleon with mixed results at 3500 hours. Had it sitting idle for years due to assorted issues after their installation. Only now after much time and parts investment have the machinery
Electronics Forum | Thu May 20 22:38:01 EDT 2021 | kumarb
For closure to all readers of this thread...many thanks to Michal for this support. Trans-tec (USA) was great in replying to our countless emails on this topic. We sourced a replacement solenoid # A041E1-48W for our Emerald-X = YV88X. The part was a
Electronics Forum | Wed May 19 20:39:28 EDT 2021 | kumarb
Elissa - SMTWenzhan ? She is great !! Have purchased many oddball and common parts from her including belts, filters, grease, etc. BTW - We placed 01005 using a nozzle she sold us with our Emerald-X. Unbelievable !! Granted the pick was hit or miss
Electronics Forum | Tue May 18 09:58:17 EDT 2021 | kumarb
Thank you so much for the advice. We were suspecting blockage but know that we have clean nozzles. Did the air blow out and removed a spot of black matter - perhaps what was an old o-ring? Nozzles are 61 and 62 posing the issue. Our tech said that 64