Electronics Forum | Wed Aug 27 13:49:02 EDT 2014 | jimmyboz
In that case, please consider one block skip mark, the same first sequence for all programs, view some feature of the X-Y table, not the PCB, that way, its just a habit. I will look into preventing advance pick, not sure if it is possible.
Electronics Forum | Tue Mar 14 18:47:29 EDT 2017 | simons
One of our Speedline Sigmaprint 400 paste printers has developed an issue. The XY table will no longer move up or down and we cannot initialize the machine for any type of on board diagnostics. Anyone familiar with this type of failure?
Electronics Forum | Thu Jul 06 19:41:31 EDT 2000 | Hermie
We recently installed a new Servo-Amp which controls the X-Y table on our CP6 machine. Eversince, we are experiencing a Cycle alarm X-reach on the machine. We tried to greased the table a little bit more but the only thing that seems to work is to sl
Electronics Forum | Fri Apr 14 13:36:44 EDT 2006 | cyber_wolf
Dax, More than likely your moveable rail is slipping on the X-Y table. Make sure there is no oil where the breaks grab the table. Sometime the breaks wear out and need replaced. The contact surface on the break lever is only a couple of thou.. We hav
Electronics Forum | Thu Oct 30 09:23:34 EDT 2008 | jwolvans
Hi, Rob. Does the table appear to hang up, then suddenly let go? If so, check the alignment of all four conveyor rail guide blocks, especially if the clamping rails have been recently removed for maintenance. After that, check the piston assembly t
Electronics Forum | Wed Oct 03 08:34:55 EDT 2018 | smp
Dear SMTnet forum users, I'm trying to debug a XY problem that i have on a sigmaprint 500 printer. The problem is that The XY table fails to initialize and SigmaPro complains with : SigmaPro received a invalid message from slave Y_INIT_ERROR I'm
Electronics Forum | Thu Jun 30 05:22:11 EDT 2005 | dougs
it's been a while since i've worked on a CP6 but there is a sensor around the X-Y table ( near the back, it's not attached to the table, it sits just below the turret area )that tells the machine if there is a board there, i think you need to set thi
Electronics Forum | Tue Mar 07 10:43:27 EST 2006 | dougs
The E has a different x-y table setup, i seem to remember the CP6 having rollers and cams to control the z table height, the CP6E has a belt driven z axis. Also i think the CP6E is slightly faster, 44K cph against 40K, still just program it as a CP6
Electronics Forum | Wed Sep 22 13:49:47 EDT 1999 | Claude Couture
The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table move
Electronics Forum | Fri Jan 16 13:27:44 EST 1998 | Douglas A. Hooper,Sr
I am looking to purchase a low cost manual P&P machine. I am interested in the equipment that has an X,Y table and an armrest for the operator. I don't want a computerized machine due to the (high) cost at this time. Does anyone have any experience w
