Electronics Forum | Tue Sep 09 16:10:15 EDT 2008 | davef
We don't know a Siemens S-27 Error Code from a shoe box, but our old friend Stefan Witte is wizard on Siemens machines. He has posted some troubleshooting guidance on his site. If that doesn't help; contact him, plead for mercy, and he probably will
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would
Electronics Forum | Mon Jul 13 10:04:06 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would li
Electronics Forum | Tue Nov 10 17:01:17 EST 2009 | jjune
2 days?? WOW! Here at our location, with MyData programming it takes on average for new projects a little over an hour with over 350 new parts. We use Aegis for both our offline programming as well as our MES and definitely have been happy with th
Electronics Forum | Mon Sep 28 10:51:02 EDT 2009 | shanenaturalpoint
My company recently purchased an MPM AP27 on the used market. I had the machine up and functional at one point, but now it is inoperable. I have correct power and air to the machine, but when I attempt to power it up, I get nothing. Red light on t
Electronics Forum | Fri Dec 18 09:07:24 EST 2009 | tommyg_fla
dave, where I work they are having the same problems with 1B31 acrylic. The coating thickness is 6-8 mils dried so that have to do several passes with an air dry between them and a final oven cure. They think that it might be related to the heating r
Electronics Forum | Tue May 11 10:57:35 EDT 2010 | ehess
Having a problem where i have no drive on any axis. Machine powers up, but won't reset. I have 24VDC from PS6 and PS1, located in the upper drawer. I do not have 12VDC @ PS2 in lower drawer. troubleshooting guide says to check DPR in/out, which I
Electronics Forum | Tue Mar 01 23:55:41 EST 2011 | cmguan79
Hi all, Need help troubleshooting for I've just bought a 1997 second-hand oven HVC102. Unfortunately, after loading profile & press run mode we found all TC READING IS ZERO & CONVEYOR READING FEEDBACK IS ZERO SHOWN ON MONITOR SCREEN ,& I LOSS PA
Electronics Forum | Thu Sep 29 18:48:19 EDT 2011 | jrsmachine
We have a Philips CSM84VZ which we acquired several years ago. It has been running fine until recently when a new employee ran it unsupervised. Since then, when in run mode, it wont't run, but just displays error code "#79:operation interrupted". our
Electronics Forum | Thu May 10 22:16:51 EDT 2012 | davef
It's bad practice to remix used solder paste with new solder paste in the jar. Further, some would argue that it's bad practice to reuse solder paste period. If economics force you to reuse solder paste, store it for reuse in an empty jar. When rea