Electronics Forum | Wed Apr 17 08:35:17 EDT 2013 | emeto
I currently run Siemens and they have their own recommendations about placement force. Most of the passive parts will be placed using 2N. For some BGA'a we will go about 4N and for certain parts that are very easy to break you should go 1N. All parts
Electronics Forum | Tue Mar 26 11:37:39 EDT 2013 | dman97
Hi Deni, I have access to the online database, but I don't see the option for machine manuals. I only see the trouble shooting guide. 2 of my machines are running a variant of UPS 3.1 on OS/2. The other machine is running an older 1.4 OS/2.
Electronics Forum | Thu Apr 18 17:42:26 EDT 2013 | navworx
Just because a feeder has 8 pins on the front > does NOT mean it is IQ. The IQ feeders started at > a certain level of feeder part number.....which i > do not remember being that many people dont use > the IQ system. > > Good Luck It has PLD v
Electronics Forum | Tue Apr 23 15:35:45 EDT 2013 | dyoungquist
Check out IPC-A-600. Revision G (July 2004) section 3.2.3 (surface) and section 3.2.4 (internal) give min/max thicknesses for various weight copper. The min also changes depending on what class (1-3) standard you are working to.
Electronics Forum | Tue May 07 09:26:38 EDT 2013 | emeto
Hello knowledgeable people, we have Omniflow 10Zone oven from 3-4 years and we changed over 20 blowers. The blower is German and I think is a very good quality(quite expensive too), but still keep getting bad. Does anyone have similar problem? Do yo
Electronics Forum | Wed Oct 23 10:00:13 EDT 2013 | aj
All, I am glad to report that this issue has been resolved at last. Issue with 40VAC contact in the Y4 crate, as the problem was intermittent it was a difficult one to trace/prove. My thanks to DEKHEAD for assistance and Maxem Engineering..... PS
Electronics Forum | Tue May 21 08:50:47 EDT 2013 | markhoch
When Delta T is measured between components on a PCB, it is recommended that the Delta T between your highest mass and lowest mass component be 4 degrees C or less. Delta T can also be measured between zones on your reflow oven. (Delta T is defined
Electronics Forum | Tue May 28 08:32:41 EDT 2013 | emeto
Hi Eric, your problem looks like a printing issue - if the part(or group of leads) missing solder is always the same. I would say you should check: 1. Stencil for any damage at this area 2. Squegee for damages 3. Adequate pin support un der the boa
Electronics Forum | Sat Jun 01 10:35:16 EDT 2013 | aemery
No! Equipment OEM's have to license each CPU box or OS they sell. Your system machine software 8.4.3? is built to run on an NT OS. Microsoft no longer supported NT when the UP2000's/AP printers were converted to NT from DOS around 1999-2000. Speedl
Electronics Forum | Thu May 30 09:41:30 EDT 2013 | giangi
Hello, I have 4 BTU Paragon 150s in the factory where I work for. One of them has a weird behaviour: in order to get the same thermal profile as for the other ovens, I have to increase a lot all the temperatures. I think there is something wrong with
.gif)
