Electronics Forum | Fri Sep 07 16:53:37 EDT 2012 | burb1999
We have Heller, 1707EXL now. It has a removable support for the mesh conveyor that just pull out (clipped in). Had an Electrovert and they were bolted on and very tuff to change out. The oilers Im not sure I care for though,they have a metal rail t
Electronics Forum | Thu Dec 12 12:44:45 EST 2013 | jaimebc
Just to add to Chad's response, there is box that you need to check in the program editor, ours is under the colum soldering unit one, click on the icon at the bottom, you should now be able to see a box " fix horizontal permanently". Check this box
Electronics Forum | Thu Apr 17 14:01:26 EDT 2014 | hegemon
And digging a bit further, are the opens at the device level (all the solder on PWB pad, none on device pad) or at the PWB (similar to pillow defect?) After answering that, I would start thinking about(in this order)paste print quality and consisten
Electronics Forum | Mon Jun 09 10:03:40 EDT 2014 | clydestrum
Well, typically we put rails on a lot of the boards due to the absence of fids and/or tooling holes. We do have a fixture that is somewhat universal that I could try to introduce into the next run. Unfortunately, the next run does not help my proble
Electronics Forum | Tue Jul 29 17:59:53 EDT 2014 | guts1872
I have had to flush the ram when replacing a TEP controller. These are kind of scetchy instructions from my notes, never could get PPM to send me any procedures. Hope this helps. Plug keyboard and monitor into RT computer and navigate to 2kla/RT/TEP
Electronics Forum | Mon Sep 29 18:37:22 EDT 2014 | spoiltforchoice
Don't know if you can do it on a MyData, but I have found that I lower the rate of failed pickups on our machine by altering the placement order of devices. Specifically insisting it does not attempt to pick sequential parts from the same lane. Of co
Electronics Forum | Tue Mar 29 03:03:42 EDT 2016 | wesleyintelli
Our MPM UP100 is not slowing the pcb carriage as it is brought under the stencil. The result is that the carriage jolts the machine heavily when it is fully loaded. The hall effect vane sensor half way along the rear rail is working correctly. The le
Electronics Forum | Wed Feb 08 01:30:02 EST 2017 | nikkilouie
Im having trouble with and Ekra x5 machine. It > works fine when up being run constantly, but if > it sits for 10-15 minutes when you try to move > the Y table to the front of the machine it makes > a loud sound as if the table is hitting/catchin
Electronics Forum | Mon Jan 09 14:18:51 EST 2017 | ttheis
Thanks for your replies. Customer designed this so we can offer them feedback on the design. Pin manufacturer said most likely too much paste as well. Reducing apeture size would be the easiest solution there. We are running a VIP70 oven with chain r
Electronics Forum | Thu Feb 02 12:39:41 EST 2017 | mnorthey
We have been using Vitronics for over 20 years with very few problems. I imagine Heller is just as good, I would rather you talk to your Solder provider Rep to find out about any add-ons you need for your specific processes. Along with that info and