Electronics Forum: stencil (Page 267 of 540)

Stencil Printers

Electronics Forum | Wed Dec 03 12:46:20 EST 2003 | swagner

For half the money you can pick up a used Dek 265 GSX which are extremely reliable printers and Dek is always on the leading edge of new performance enhancing upgrades.

Stencil Printers

Electronics Forum | Thu Dec 04 00:15:57 EST 2003 | masr

I think Ekra is a good option, is very easy machine to use and is not over saturated of wires, joint cards, servo cards, and so forth, very simple for diagnostics!

Stencil Printers

Electronics Forum | Wed Dec 10 08:41:26 EST 2003 | Craig P. Brown

Dear Mr. Petty: I woould welcome the opportunity of discussing your application requirements in greater detail. Please advise a convenient time that I may personally contact you. Thanking you in advance for your consideration of DEK.

Stencil Printers

Electronics Forum | Thu Dec 18 20:07:38 EST 2003 | alwil

Hi Grant, I have experience with both MPM and DEK and can say both are excellent. I am currently using a number of DEK 265's and have received good support from Vema. Remember, you only get what you pay for. Cheers.

Stencil Printers

Electronics Forum | Sat Dec 20 10:46:59 EST 2003 | browning

I have had both DEK and MPM. I have had far better success with the DEK's. They are far more reliable, require less maintainence and are on-line more than any of the MPM's I have had. I have only DEK's on my lines now.

Stencil Printers

Electronics Forum | Sat Dec 20 21:01:57 EST 2003 | Grant Petty

Hi, Ok, and thanks for the advice, I am going to check into the DEK printers heavily, and see how they work. As of yet, I have not seen one in operation, so I have a lot to check out. Thanks for the advice! Regards, Grant Blackmagic Design

Stencil Printers

Electronics Forum | Tue Jan 06 15:22:49 EST 2004 | browning

Grant, Sorry for the delay in a response, I just got back into the office from the holidays. I have 265's, Horizons and Eclipses.

Stencil Printers

Electronics Forum | Thu Feb 19 17:03:50 EST 2004 | Grant Petty

Hi, We settled on a high end DEK Horizon printer, and thanks to everyone for the info. The machine arrives on Monday, so this will be good! Regards, Grant Blackmagic Design

TOOL MANAGEMENT

Electronics Forum | Mon Jan 05 18:00:38 EST 2004 | davef

We consider stencils to be 'tools'. That way, we take steps to make sure they are available, when we start a build that requires them.

TOOL MANAGEMENT

Electronics Forum | Mon Jan 05 21:52:59 EST 2004 | P.laxmanan

Dear Dave, Whether U have conducted any study on lifetime of the stencil.We also wnated to conduct the study.Can U give some gudelines?


stencil searches for Companies, Equipment, Machines, Suppliers & Information