Electronics Forum | Mon Dec 03 18:30:29 EST 2018 | slthomas
Not sure how the lead screw drive gear is locked in place but is it possible that it's slipping in both directions (when driving the rail both forward and backward) and then not catching until after the other end has already moved some? You could h
Electronics Forum | Mon Dec 03 18:31:06 EST 2018 | slthomas
Not sure how the lead screw drive gear is locked in place but is it possible that it's slipping in both directions (when driving the rail both forward and backward) and then not catching until after the other end has already moved some? You could ha
Electronics Forum | Tue Mar 05 11:07:17 EST 2019 | sumote
Looking to purchase a DIP lead forming tool. The tool that has the 2 rollers that let you place the DIP part on the rail and run it between 2 rollers (ball-bearing?). I found a place that once sold them. They were called an RS Pro IC Insertion Tool
Electronics Forum | Mon Jun 10 10:12:42 EDT 2019 | assuredtech
What is the year, make and model of your oven? Are you running it with Upstream and Downstream (pre-reflow, post-reflow) conveyors? Is the qty of the product low, medium or high? What is the max process width of the oven? what is the max board with o
Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn
Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier
Electronics Forum | Tue Jul 14 15:26:06 EDT 2020 | dekhead
Not as straightforward a question as you might think... due to the multiple rail systems (at least 4) used on Europa. But what you seem to be describing is the single stage conveyor, which uses same belt as used on the GSX, and majority of Horizon /
Electronics Forum | Thu Aug 13 15:46:57 EDT 2020 | ironsmt
I'm having a problem getting sufficient solder reflow on a SMD part. The board design (which can't be changed) is covered in ground planes that cause a lot of uneven heat distribution. I believe heat is wicking away from the culprit part, causing t
Electronics Forum | Tue Mar 02 12:29:52 EST 2021 | astarotf
Hi Travis H, Thank you very much for answering and helping. Apparently, but I'm not sure what the X linear bearing assembly is. The replacement part I am looking for is I believe this it
Electronics Forum | Tue Mar 02 16:05:46 EST 2021 | travishemen
The document I am using is through Universals Voyager software. It contains all the manuals, part lists, procedures, etc. It is an installed piece of software so it would be hard to share. I was able to find the pdf of this breakdown. I assume th
Electronics Forum | Wed Mar 02 18:23:57 EST 2022 | proceng1
In my experience, take whatever the manufacturer tells you the minimum keep away area is and double that for standard use. I'm not saying it can't do what they say, but no matter how precise the software, the motor control, the lead screws and rails
