Electronics Forum | Thu Dec 01 14:48:48 EST 2022 | peterm
Hi, The detailed instructions should be in Voyager under PTF Installation. It's basically a kit where you pick up a metal plate and you teach that component on the belt directly. If you don't have access to the kit I'd just start of with the default
Electronics Forum | Wed Dec 28 11:05:27 EST 2022 | atpico
We have 7.2E (MS-DOS variant) software version on our printer and there are some annoying bugs and less than optimal NPI process (when the new board need to be put on and put off the rails several times during NPI teaching). Is there a known newer/be
Electronics Forum | Wed Jan 24 15:49:32 EST 2024 | carlos_s39
Hi all, Recently the place where I work at purchased an SMT assembly line. The stencil printer is a used DEK Horizon 03i. We received no manuals with it and are having issues with the cleaner. The motor does not move and it does not move along the ra
Electronics Forum | Thu Aug 30 11:59:00 EDT 2001 | Spanky
Hey all, I have 3 questions about reflow. Hopefully someone can help me. 1. I am having a problem. I set the peak at 230 and my mole thermocouples are telling me the temp in that zone gets to 237. How is this possible even if the thermocouple
Electronics Forum | Tue Aug 13 17:34:44 EDT 2002 | pjc
The Electra is Electrovert's top-of-the-line wave solder machine. Just about the best you could get. Conveyor concerns should focus on the condition of the extruded rails. A machine that new should not have a problem, buy worth a look see. Find out i
Electronics Forum | Wed Aug 02 15:19:29 EDT 2006 | SWAG
Sounds like air pressure is set O.K. The next thing to check is that the platen surface that the x and y axis ride on is perfectly clean. After that, you should knock the camera off the platen and make sure that all of the small air nozzles are blo
Electronics Forum | Sat Aug 26 10:28:05 EDT 2006 | Ola
Hi, this is not a solution for your o-ring "belt" problem but a guideline for the future on an o-ring "belt" (wrong word as it is Not a belt) conveyor. These crazy O-rings have a small radius which makes it somtetimes hard to do a conveyor width adju
Electronics Forum | Tue Aug 13 10:09:10 EDT 2013 | dyoungquist
We have a Heller 1707EXL that we use for lead and lead-free production. It has both a mesh belt and edge rails. We run 90% of our assemblies on the mesh belt (leaving the edge rails wide open). I have noticed when profiling a board on the mesh bel
Electronics Forum | Fri Jan 10 11:32:52 EST 2014 | rgduval
Hi, Hans, I would have suggested swapping the MOT card out to see if that fixes the issue (or, changing the MOT card with another one to isolate the card), but, it sounds like you've already done that. I'm surprised that MyData would point you towa
Electronics Forum | Wed Oct 03 23:42:32 EDT 2018 | gaintstar
SMT Reflow Oven Factory http://www.flason-smt.com/product/SMT-Reflow-Oven-Factory.html Introduction of SMT Reflow Oven Factory: 1. Windows XP platform, user friendly interface and easily swap between bilingual of English & Chinese. 2. Digital contr
.gif)
