Electronics Forum: centroid data (Page 1 of 12)

Convertion Gerber to P&P data

Electronics Forum | Wed Jan 11 10:12:23 EST 2006 | ratsalad

I've used an old version (maybe 7 or 8 years old) of GC-Place to convert gerber to centroid data. It is semi-automatic. If I remember correctly we'd start by selecting the pads for the largest components first. The software would find matching gro

Convertion Gerber to P&P data

Electronics Forum | Thu Jan 05 13:29:43 EST 2006 | jax

Nothing is automatic from Gerber. Gerber is stupid data. (Pads are defined, not components) I think you are looking for Centroid Outputs not CAD. Cad defines the components on the board as well as the board itself. Centroid gives Ref. Desig., X, Y,

Convertion Gerber to P&P data

Electronics Forum | Thu Jan 12 01:07:34 EST 2006 | pavel_murtishev

Good morning Mark, CAM (Computer Aided Manufacturing) products are designed to solve such tasks. You can try CAM350 for example. CAM350 understands different ASCII exported data from different CAD systems. CAD ASCII export contains all necessary inf

Convertion Gerber to P&P data

Electronics Forum | Wed Jun 20 14:34:23 EDT 2007 | pnguyvu

Hi Mark, You can use the software called GC-PLACE to convert centroid, there are alots of SMT process engineer using it. Regards Steve USA STENCILS

what software is out there that will extract XY centroid from gerber data?

Electronics Forum | Sat Feb 04 10:02:53 EST 2017 | mikekeens

GC-PowerPlace from http://www.graphicode.com/ will do this but takes time to get to grips with and can be time consuming depending on the design complexity and the type of data available. Ideally i recommend asking for CAD data as this will contain

what software is out there that will extract XY centroid from gerber data?

Electronics Forum | Mon Feb 24 12:41:18 EST 2014 | mi

Depending on what X-Y centroid / CAD data you need, there are different SW I've used to do the job. If you need PCB gerber "artwork" (rounds, rectangles, lines, squares,...geometric figures), you can use GraphicCode GC-Place & such - load the gerber

what software is out there that will extract XY centroid from gerber data?

Electronics Forum | Sat Feb 15 15:01:06 EST 2014 | dexter11233

At my company we have to capture centroid data from gerber information on almost a daily basis, so tinkering and toying with quicker and easier methods of getting the job done are fairly common place with us. As stated by Richard Larue UniSofts cad

what software is out there that will extract XY centroid from gerber data?

Electronics Forum | Fri Oct 30 18:55:20 EDT 2015 | hawaii11

You can generate XY Centroid, from Gerber files using FAB 3000 V7 https://www.youtube.com/watch?v=KSHwBJ5u3uo www.fab3000.com www.numericalinnovations.com


centroid data searches for Companies, Equipment, Machines, Suppliers & Information