Electronics Forum | Mon Aug 31 09:53:59 EDT 2009 | fujiphil
after sending all the datas.... proper, program and status... Re-boot the machine...
Electronics Forum | Wed Sep 02 08:03:24 EDT 2009 | kircchoffs
disable windows firewall
Electronics Forum | Wed Aug 26 17:06:56 EDT 2009 | andoe
when i transmitt data to the cp6 every thing seems to go okay until the end and i get a -- "A21E transmission error". i have checked the cable (i can program my IP3) any ideas? thanks ron
Electronics Forum | Sun Aug 30 15:32:33 EDT 2009 | jimmyboz
most fuji error codes are 8 digits, A21E is 2100A21E, it is a report from the MCS that transmission has failed (we knew that) Hit control E from the main screen of the MCS, there should be another error reported from the cp6, ie. 1101000 is x data ou
Electronics Forum | Tue Sep 01 05:28:49 EDT 2009 | aj
start skipping out some parts and try to transmit? could be a dodgy part data... Best thing to do is skip out everything except one part and see how you get on with the transmission and work from there. If it transmits start addin a few more until y
Electronics Forum | Tue Feb 01 14:26:53 EST 2005 | johnw
Just for starters you are experiencing a possible closedloop feedback error 1 your motor is on its way out 2 increase the reach pulse in propers 3 check gain of servo mail me for more info
Electronics Forum | Sun Jan 29 11:59:13 EST 2006 | johnw
Hi Better to check the table calibration and wedges also the rack and pinion gear at the back of the table for control if you go into mechacheck you can set the servo and the calibration data if its an early cp6 its quite simple to set up if its a cp
Electronics Forum | Tue Jul 12 03:57:55 EDT 2005 | woodglass
Hi, In the CP6 propers, there are values: PCB Check Position X, & PCB Check Position Y. These are the servo counts that the X/Y table moves to when checking if a PCB exists on the table. Your sensor does not detect a PCB, probably because when checki
Electronics Forum | Tue Sep 01 11:46:09 EDT 2009 | andoe
when the cp6 loads a board everything seems normal / as the table drops the pcb lines up onto the origan hole and then instantly fails with -- "original pin error" we have run this board before. any ideas? thanks
