Industries most advanced closed loop rework station available. Using highly reliable precise and unique IR heating systems the IR500A and IR550A have set themselves apart from other rework stations by being able to simply remove and replace component
Electronics Forum | Mon Aug 08 06:27:26 EDT 2005 | Hi Peter
Better use Ersa IR550A or IR650A. http://www.ersa.de
Electronics Forum | Mon Nov 25 07:47:15 EST 2002 | Yannick
And what about the one from Ersa the IR550A?? It's more that 20k but did someone tried it?
Electronics Forum | Tue Mar 09 19:40:47 EST 2004 | Vijay
The shorts happen at corner of the BGA. The PCB thickness is 1.6mm, It is a PC motherboard with all thru hole connectors mounted on.The preheating is done using IR heater and the temp is 120-160 for about 70-80 sec.I am using ERSA IR550A
Electronics Forum | Tue Mar 09 19:40:55 EST 2004 | Vijay
The shorts happen at corner of the BGA. The PCB thickness is 1.6mm, It is a PC motherboard with all thru hole connectors mounted on.The preheating is done using IR heater and the temp is 120-160 for about 70-80 sec.I am using ERSA IR550A
Electronics Forum | Thu Jan 06 21:41:20 EST 2005 | James Khor
You can using Ersa IR550A Rework System. The unit was NOT using any hot air process. IR550A Rework System is worldwide the only system with a genuine closed loop control system. Which employs the current temperature at the component in order to regul
Electronics Forum | Wed Jul 09 15:54:51 EDT 2003 | Louis
I need advice from someone who has already soldered this part or similar fine-pitch BGA with metal heatsink on top Should I solder it in the oven or it's better with a rework station (IR 550A Ersascope) Thanks All
Electronics Forum | Fri Mar 12 12:59:50 EST 2004 | babe
Sorry for the late reply, I am an ersa dealer may I suggest mounting an alternative thermocouple attached to a DMM in close proximity to the BGA. See what the differences are in your readings from the DMM and the Digital temp reading on the IR550A. I
Electronics Forum | Wed Aug 02 06:03:16 EDT 2006 | jammy
Presently I am looking to buy either a PDR X410 or ERSA IR550A rework mahine.The PDR model is the favourite at the moment however I would not turn down the ERSA model or any other similarly specified infrared based rework system.Unfortunately I have
Electronics Forum | Tue Feb 05 16:06:48 EST 2013 | mlevesque
We are looking for a new BGA rework station. We got an ERSA IR550A and we are not very satisfied. I'm not sure that IR reflow is the better solution because the top-side heating is too large. I think is better with a convection "forced-air" heat.
