Electronics Forum: large (Page 1 of 189)

Epoxy for holding large inductors

Electronics Forum | Wed Jan 14 17:21:04 EST 2009 | davef

We love Loctite 3609 as a chip bonder, but would never consider it to secure large components

large smt board to reflow

Electronics Forum | Thu Aug 10 05:53:10 EDT 2000 | pascal MATHIEU

hello everybody , i am looking for the elementary caution you need to take when you reflow large board with several thousands of smt components . thank you for your advise

IP3 Feeder for large cap.

Electronics Forum | Thu Mar 11 09:47:26 EST 2004 | johnchung

Hi Allan You need a feeder 44 from Hover-Davis.

Epoxy for holding large inductors

Electronics Forum | Wed Jan 14 13:58:07 EST 2009 | swag

We use Loctite 3609 - it's good stuff.

Epoxy for holding large inductors

Electronics Forum | Wed Jan 14 17:07:46 EST 2009 | davef

In BIG-boy, high vibration applications to secure large components, we've used 3M #2214 structural adhesive [One part, 250*F (121*C) curing 100% solids, paste consistency epoxy adhesives designed for bonding metals and many high temperature plastics

IP3 Feeder for large cap.

Electronics Forum | Fri Mar 05 00:53:09 EST 2004 | alwil

I have an Electrolytic capacitor which is 17mm in diameter and is 16.7mm in height. It is presented in a reel,44mm x 24mm. I want to know if there is a suitable feeder available to place this part onto a Fuji IP3. Thanks, Alan.

IP3 Feeder for large cap.

Electronics Forum | Mon Mar 22 00:17:41 EST 2004 | D. Sanders

Alan, Fuji also has a standard motor feeder FMB-44 that should handle this component (believe the depth is right at 17mm for the feeder). This is the motorized feeder, not the old mechanical ones that they use to sell. D.

IP3 Feeder for large cap.

Electronics Forum | Wed Mar 24 21:11:05 EST 2004 | longpham246

Contact Lean Stream in San Jose California, ask for Bob Jones at 408-605-0141 for best solution. He has new feeder at extremely low cost that work out best for me. Long Pham

Reflowing large aluminum electro. caps

Electronics Forum | Thu Mar 03 09:29:12 EST 2005 | jdengler

This sounds like you are using a straight ramp profile. For this type of an assembly you may need to use a soak type profile. Most solder paste providers show you both types of profiles that work best with that paste. I would try using that profil

Reflowing large aluminum electro. caps

Electronics Forum | Thu Mar 03 10:59:37 EST 2005 | Rob

Also try boosting the bottom zones up to get extra heat in. Now try this at lead free temperatures & watch them go pop as the air inside expands & vents at the base. O to be in America & be free of our wonderful european decision makers.


large searches for Companies, Equipment, Machines, Suppliers & Information

MSD Dry Cabinets

PCB Assembly Supplies - ONLINE STORE
Industry 4.0 Reflow Oven

Easily dispense fine pitch components with ±25µm positioning accuracy.
SMT & Test Auction From All Over The West (Best in the West)

Best Reflow Oven
Electronic Solutions R3

MSD storage in desiccant dry canbinets