Electronics Forum | Tue Feb 11 00:21:54 EST 2014 | bren
I suddenly encountered this error F-AXIS-C/9 Error says Axis has unstable zero point. Any advise?
Electronics Forum | Thu Feb 20 13:56:18 EST 2014 | rgduval
Brendan, Unfortunately, I no longer have MYData equipment in my shop (I moved to a new company), so, I can't help with finding part numbers. I do know that you can buy the motor/counter units separately on the open market..and, I think you can buy
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval
Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-
Electronics Forum | Mon Feb 17 18:53:34 EST 2020 | richgreen01
Hi all I am experiencing z force sensor errors on a couple of different nozzles ( not hydra ) any help appreciated.
Electronics Forum | Tue Feb 18 14:37:41 EST 2020 | bk
What type of head do you have on your machine a midas head or a zi-fi head? Regardless of which you do have I would make sure that the head is clean where to tools go into the head. Use a soft swab or something similar so you do not damage the z forc
Electronics Forum | Tue Mar 24 23:44:17 EDT 2020 | kghadiya
I am having trouble programming circuitcam for mydata (my9) pnp machine. My question is, when i digitalize the gerber file what should i take care to get required output for my9? In my9 i cant see exact positions of all the components. I have assign
