Electronics Forum: sake (Page 1 of 4)

In need of SMT-Maestro install files

Electronics Forum | Thu Jan 10 13:48:56 EST 2019 | dontfeedphils

Super late reply, but I just went through the same hunt and thought I'd post the files for posterity sake. https://drive.google.com/open?id=1Ztj-AUou6oiZiIRkJinBWuaVorWYvP2_

Slow day at the 'net

Electronics Forum | Tue Dec 19 19:11:37 EST 2000 | Michael Parker

Not much activity here in the past few days. Just wondering if you all have been egg nogging it too much in preparation for jolly ol' St. Nick. Or could it be that some have taken to smoking the mistletoe? I hope DaveF. has recovered OK from his re

BGA rework

Electronics Forum | Fri Nov 09 20:15:26 EST 2001 | caldon

I concur with Dave.....I have done this often with little fall out. After rework reflow we would x-ray just to ensure an acceptable joint structure. Just for curiosity sakes....are you removing a defective BGA and replacing with a good one? Site pre

uBGA (.5mm pitch) printing woes

Electronics Forum | Fri Sep 22 14:10:19 EDT 2017 | slthomas

Just for the sake of passing along the information, the fine grained stencil provided zero improvement over the standard PhD stainless and was not nearly as helpful as the baked-on nano-coating. We probably won't be trying that again unless we go und

Reg. Reflow process for BGA pitch 6,5

Electronics Forum | Wed Oct 06 17:29:50 EDT 2021 | emeto

The question is can you consistently heat up the board to the desired temperature? You need to measure temperature with thermocouples and plot temp/time diagram. Based on the datasheet chemistry you use, you can see what is the recommendation and if

Re: Release difficult from thick stencil

Electronics Forum | Fri Oct 27 11:34:30 EDT 2000 | Steve A

Wister, I agree with the other comments as far as challenging the customer, and minding proper height/width or better yet area aspect ratios. Let's assume you need to go with a .012" stencil for arguments sake. Talk to your stencil supplier about h

Placement machine comparison

Electronics Forum | Tue Jun 18 17:01:50 EDT 2002 | kenbliss

Todd, for the sake of the forum could you please spell out a few key line items about why you state the Juki machines is Junki. Clearly you are unhappy with their machine. The best purpose of this forum is to identify problems with machines, proces

extra zeros very confusing....

Electronics Forum | Tue Oct 22 14:55:50 EDT 2002 | slthomas

Dave, are you telling me that yer tryin' to pawn that off as a superscript "degree" symbol??? Wass' wrong with 183C, fer criminy's sake? (fighting urge for more defensive ranting) I'd swear a couple of old posts changed the way they displayed after

MPM screen printer

Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM

Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv

BGA soldering

Electronics Forum | Tue Dec 18 08:08:09 EST 2007 | itwasbill

Hi all, How can I convince my equipment purchasing supervisors that to properly solder BGA's a 7 zone oven would be far superior than a four zone? We currently own a 4 zone oven and I'm fearful that the BGA will not get adequate heat for solder


sake searches for Companies, Equipment, Machines, Suppliers & Information