Electronics Forum | Mon Sep 17 16:03:13 EDT 2001 | jschake
The results from an experiment comparing 27 different combinations of pad dimensions concluded that the pad design with 15 mil pad length, 12 mil pad width, and 9 mil pad separation produced the best assembly yields. A 5 mil thick laser cut stencil
Electronics Forum | Tue Apr 27 12:32:53 EDT 1999 | Frank Hinojos
What is the current spec for sizing PCB pads for a land grid array? How about for a ball grid array? Are there industry spec's I can reference? Thanks, Frank
Electronics Forum | Thu Sep 07 03:57:39 EDT 2000 | Steven Cheung
Does anyone know of a freely-available document which discusses the main considerations of BGA assembly and inspection (x-ray?). l need to know about pad sizes and inspection standards and when to underfill and when not to etc.. l am looking at ass
Electronics Forum | Thu Mar 31 12:13:28 EDT 2022 | cbart
That is a tough one because of package size I agree, as noted previously it would be good to know what the current PCB pad layout is. first thought does go right to an adapter board of course! is this a volume build or just 20-50 pcs? dead bug and ha
Electronics Forum | Tue Nov 28 21:16:17 EST 2006 | davef
J Rose at EMPF says: The introduction of no-clean solder fluxes in electronics manufacturing has given rise to greater levels of solder balling simply because the opportunity to remove them in the wash process does not exist. They are typically cause
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Sat Feb 10 10:08:04 EST 2018 | griinder
We recently acquired used MPM Accuflex. Immediately I noticed the live vision is mirrored. This makes it incredibly difficult to teach fiducials. I noticed some smudges on the lens, which leads me to believe the camera assembly was "worked on" at som
Electronics Forum | Fri Jan 16 16:34:01 EST 2015 | rgduval
It's a four-spindle head. I've already learned the joys of the size of the nozzles...on a job that had an 0603 cap a bit too close to an SOIC. The first panel ran, and the cap placed after the IC...and I had parts everywhere. Got it figured out an
Electronics Forum | Tue Apr 27 13:00:05 EDT 1999 | Justin Medernach
| What is the current spec for sizing PCB pads for a land grid array? How about for a ball grid array? Are there industry spec's I can reference? | | Thanks, | | Frank | Frank, Refer to the device manufacturers. they are going to have a recomme
Electronics Forum | Wed Apr 28 14:41:45 EDT 1999 | Bob Willis
| | What is the current spec for sizing PCB pads for a land grid array? How about for a ball grid array? Are there industry spec's I can reference? | | | | Thanks, | | | | Frank | | | Frank, | Refer to the device manufacturers. they are going t