Electronics Forum | Thu Aug 09 16:41:12 EDT 2001 | johnw
Dave , you know it's your cheery disposoition I love.... Ok so the process: Process is Double sided reflow for SMT & PTH via the wave. Like I said or did I, I forget and can't check back...it's a spray fluxer with noclean mutlicore NR3s-06 water b
Electronics Forum | Thu May 09 17:16:16 EDT 2002 | davef
Russ makes a good point. While your profile probably meets your paste supplier recommendations, it may not be proper for the component. * Paste suppliers offer general recommendations for tin / lead interconnects. You need to modify that for board
Electronics Forum | Tue Aug 13 20:58:06 EDT 2002 | davef
Peterson: Ionic flux residues when combined with moisture and a voltage differential can plate conductive �fingers� on the surface of a PCB, but that doesn�t sound like what�s going on here. Your NC flux should not be particularly conductive. For
Electronics Forum | Thu Aug 08 11:58:25 EDT 2013 | rway
I am not that familiar with the older systems. The software should be supported on both old and new alike unless you are limited by the operating system, but the camera will obviously have a lower resolution and perhaps the filtering is not quite as
Electronics Forum | Thu Mar 01 08:40:20 EST 2018 | emeto
Concerns about this machine: 1. It is very light - only 500kg. I will seriously doubt real speed of 7500cph. 2. 8 cameras???? Whatever the concept is, this is weird. imagine how a calibration of this toy will look like. 3. Feeder positions - only 6
Electronics Forum | Mon Feb 22 12:04:15 EST 1999 | Dave F
| Please could you suggest a recommended aperture sizes for | printing of smd adhesives. Any recommendations on stencil thickness as well as stencil finish will be appreciated. | Mark: About the only rule of printing adhesives is: Keep it off the
Electronics Forum | Mon Aug 02 09:26:15 EDT 2004 | davef
Q1: How do you define torque setting for screw? A1: Talk to people at your nut supplier. Some nut suppliers post torque tables on the web. For instance: http://www.thelenchannel.com/1torque.html http://www.marfas.com/Ttorque.shtml http://www.pac
Electronics Forum | Wed Oct 13 03:38:21 EDT 1999 | Paul Gerits
Hi Morris, I work as a technical consultant, application specialist for Philips EMT (SMT machine suplier). For cost per placement complex calculation can be made. To make a easy one just to hav an idea you can use following. Information needed: Pr
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
